gmrhodes13

Hello and welcome aboard, good luck with the build

Came out a treat, nice work

Hello and welcome aboard

Enviar un mensaje privado a @sskunky él puede ayudar

You may want to reduce the paint on the ab buttons, also the large plate shouldn't have rounded corners Your sides are overlapping, perhaps loosen the belt a little or add some foam behind the ab/kidney to hold them outwards You have gaps in the bottom ridges of the thighs on the rear, you could add some scraps of abs behind Good luck with approval

A nice guide to follow:

Hello and welcome aboard

Great work, always nice to see other ideas on how to solve a problem

Closed early

Very inspiring and generous, well done

Great work, coming along nicely

Hello and welcome aboard

Congratulations and welcome to the EI ranks trooper

Hello and welcome aboard, good luck with the build

Congratulations and welcome to Centurion trooper

Hello and welcome aboard

Nice work. You may want to tighten the strapping on the sides, appears your kidney plate is sticking outwards on the front view as well as there is a gap on the side view. Remove the paint on the ab side snap Also try to bring your biceps down a little more, would reduce the gap at your elbows. Appears one of your shoulder straps is sitting behind the back plate in the rear image. Calf rear cover strips should stop below the top ridge. Drop boxes do not appear aligned with the end of the plastic belt section I would advise you look through some other applications as you appear to be needing a few other images Could you also post a close up of your detonator front and clips as it appears to be quite long and has a large gap between end caps. Also appears the end caps are smaller than the grey tube or hanging off? You could also add a little white around the tips of the hove's (mic tips) and also try to define the curves of the vocoder a little more

Very nice, you just need to add some tube and trap stripes, unless you are going sandy

Getting close, nice work

Coming along, just watch the paint on the gums around the teeth. Frown is painted gray and does not leave the teeth area. Vocoder could use a little touch up as well Also for getting really nice thin black lines you can use a permanent marker

Congratulations trooper and welcome to the ranks

Send a PM to @sskunky he'll be ale to sort you out

Nice work, you may have to watch your drop box placement, a little E6000 can hold the elastic in place I'd also check you spacing on the TD, gap between end caps and plate look a little small Good luck with approval

When in doubt check out the gallery section.