Leaderboard
Popular Content
Showing content with the highest reputation on 10/16/2022 in all areas
-
First post changed.3 points
-
Ok, so I decided to add a bit more weathering, as it really didn't look like much after later consideration. I can always remove some if I overdid it I personally think it came out a bit better...?2 points
-
And updated It now reads as follows.... Correct Aerators/Hovi-MIX tips are present. Screens used shall be of a wide type mesh. The rim of the mic may be weathered, and the inside raised area painted white. Interior sides shall be painted black, mesh can also be painted black.2 points
-
As we know the mic tips where white and had been painted black and no doubt when filming started would still have been all black, then some of the rim would have been rubbed of from general wear and tear, so should there not be an option for black rim? There are examples of only a slight amount of white visible. Previous conversation here
2 points -
I didn't start this thread until late in the build process, so I might be light on WIP pics. Oops. Next build. Got a kit from Faraway Creations in Colorado. Got pretty much all the torso, arms & thighs done. Had a bit of a snag with the calves, more on that later. In progress with the helmet at the moment.
1 point -
Went to the local church’s trunk n’ treat. Mostly hung out with friends and messed around in costume. Was pretty fun.1 point
-
Modified BS lid I added the rear groove by cutting a 1.5 piece of styrene at the height needed from the black section. Stuck that on with double sided tape. Then VERY CAREFULLY went round with a needle file and kept going until the desired depth After painting I added black vinyl in the recess running round the bottom Pauldron from Trooper Bay with added vinyl1 point
-
What's going on my 505 brother! Don't hesitate to reach out with questions. We can help you here or the local garrison can help you in person.1 point
-
Can change it to Tips may be weathered, that allows both.1 point
-
+1 on Glen's observation. All look weathered off to me. The originals likely started black dipped and had the tips rubbed white with natural use. Painting the tips white originally would give a different wear pattern than any of the screen examples display.1 point
-
You could fill the hole/s with ABS paste, have a look at Gerald's fix for moving his Han snap, also how to make ABS paste1 point
-
I just created an "imgur" account so I can upload better pictures of my build. I just read the post about how to upload pictures -__- I am not tech savvy... but getting there.....1 point
-
In addition to Joseph announcement, these two images have been added to the CRL gallery tab that appears at the top of each CRL1 point
-
Looking good Mark. Good luck.1 point
-
I have my under-suit, boots, and neck seal. I officially put my armor deposit down yesterday!
1 point
