ukswrath

Without screen shots of the belt's interior I'm guessing the drop box is held to the waist belt itself, using either a wide strip of nylon webbing or elastic. The following screen shot shows a drop box flipped over with the connecting material exposed. Hope this helps

Thank you

Andrew your waist belt will naturally squeeze down the Ab and Kidney. If the posterior is sufficiently connected to the kidney it should follow suit. Keep up the good work

Also, a photo showing the back side of the waist belt please. Thank you

Most common is the bottom of the thighs

Hey Jamie we're still waiting the a closer photo of the TD screws. Soon as we have that we can move forward.

Perfect thank tou

Hey Candido we'll be with you shortly. While you're waiting could you post a photo of the helmet right side please. Thank you

Awesome! Congratulations

Sad to hear

Awesome Job! Orange tote and gloves, looks like a weird science experiment

I have both ATA and Anovos kits, 3,4,5 ribs are all possible regardless of chest surface space. The important factor is to determine what you need. If you have minimal gap between the chest and back plates the go with 4 or 5 ribs as seen with screen used suits. Less space between plates use 3, though I wouldnt recommend any lower than 3.

You can use round stencils found at your local craft store.

Honestly I don't think there's a costume I've built I haven't given some area a hot water bath lol. Looking forward to your results.

One more request, can I get a closer photo of the Thermal Detonator screws please. Thank you

Adding to the above, where you go from here depends on what method you're going to use to close up the calf. If you're shooting for screen accurate with straps and hooks then yes as Paul mentioned reshaping the calves will need to be done. For the record unless you're extremely crafty with a heat gun I would advise against it, using the hot water method is much safer and will net the same result. If you're going to use velcro then I suggest leaving them the way they are. Industrial strength velco will easily hold the two sides together IMHO.

Perfect thank you

Congratulations trooper hope to see you at Centurion

Congratulations Freddy

Hey Jaime welcome, one of the DOs will be with your shortly. Before we get started could you post a photo of the right side Ab male snap and blaster "D" ring please. Thank you

Perfect regarding the TD, looked a little long, sorry.

2nd that

Good luck

Looking good Lorelei. A little helping hint, your TD should be roughly 7 1/4-1/2 total in length. Keep up the great work.