gmrhodes13

I use a belt but found that tended to pull down a bit so I added a set of braces too, problem solved. Looking good

Where you have you're finger looks good, I left a little more as my biceps would have ended up a bit loose. Just trim trim a little less then try it, you can always take off more, but you can't put it back

Looks good, ideal placing for brackets is 1/8" in from end caps

I used a two piece setup, I use a long sleeve Tee and womens leggings, cheap and works for me

I've got the popcorn and the deck chair ready, dam no beer

Clamps the 2nd LOL, awesome

Looking good so far, just watch those brackets for the elastic on your bells, they may interfere with you biceps

You're first ever cut of new armor can be very scary, it's not until you have taken the journey that you realise what was all the fuss about.

I think we still have the winner, Jabba the Bucket

I used a satin black for the vocoder, and a gloss black for the lines and edging on the lid

Looking good, just a few tweaks and you nearly there

Congrats now lets get cutting

Go to a nail salon, I am sure they would let you have some, just flex your muscles a few times and wink

Nice TD mod lol, lid lines are looking awesome well done.

It's more how the guards fit over you gloves, not gloves to your forearm. I place my handguards just over my knuckles, because I used the silicon the guards can flex with the knuckles bending, on the screen accurate gloves you can see images where the left glue from this section and they just stick out when the knuckles are bent .

Some info in this thread here

Now that you have posted a close up of your lid you could clean up the black lines a little, wouldn't take much and would really make a big difference to the overall look

Can't wait to see the updates, do a little research as there are some quite good mods you can do to these kits

Be nice to see approved Hero's actually wearing grappling boxes for a change

I wish you good luck, mine is still on hold doing a tusken workshop for 12 and have orders for 5 Merr- Sonn blasters over at IOC so going to be busy for a little longer lol. I have to stop saying yes to helping people, nah you no I can't

Well done

Very nice, you could also add a retractable id tag cable for realistic throwing

E6000 is normally used, yes it takes a while to dry but it is a very forgiving glue and can be removed by rubbing your thumb across it. Zap and super glues are an instant cure glue but can create some heat and also blemish abs, not as strong as E6000 either.

Nice looking bucket only problem is you have added the tube stripes too low down, they should be a pencil width from the cheek, this may pass basic but not EIB and Centurion

I like the strapping and especially the double snaps, much safer if one lets go you still have another in its place, I use this on my arms as well