Hey Mark, good work on your build. For EIB I can't see anything holding you up, you may want to edit your original post and add an image of your gloves. I can't tell if they are rubber (chemical) gloves, assuming so though it is hard to tell so DOs may ask for one.
I'd adjust your strapping to get your shoulder/chest gap tighter, and bring up your forearms like, a cm at most to even the gaps out.
If you plan on going for Centurion, which I hope you are, you will need to do a bit of work. A few things I spotted:
- I can't tell if you have the correct helmet ear screws, all 3 per ear need to be the correct V-shaped slotted screws.
- Your left drop box looks a tad off (should line up with end of belt), probably just a strapping issue. Some people add a dab of glue to keep them in place on the belt (see Tony's build thread).
- You'll need to use some ABS paste on your kidney shims so that they are flush/seamless.
- If you can adjust your strapping to tighten up the gaps in the back between your back/kidney/butt plates, it is highly suggested.
- Your vocoder lines could use some cleaning up (see any other Anovos Centurion submission thread for reference, this is a common ask, because Anovos can't paint helmets properly).
Good luck on your submission, the DO's will probably have a lot more to say on Centurion suggestions, until then just please be patient- with Elections etc. it is a busy time, I'm sure they will be with you soon.