ukswrath

Looking good Jeff

BAH! Humbug

Nice work A.J.

Perfectly acceptable

Congrats Rat

Very nice Eric. Always good to read builders experiences. Troopers Helping Troopers

Congratulation Martijn

Congrats on the MEPD deployed

1. Install velcro on the front of your boot and bbn inside shin to maintain alignment. 2. If you E6000 the cover strips, remove than trim armor to fit. As you mentioned a few small tweeks and you should be good to go.

Short and quick answer regarding the kidney notch, it's optional even at L3.

Brentwood

Looking good Tom. Sorry I wasn't able to make it to the party, on a positive note my shop is open most weekends if you want to come by and build some armor together.

Roger that

looking good

Blue - Too much, either tighten or ditch the elastic and use nylon webbing. Yellow - No, it's perfectly acceptable the way it is. Green - Optimum would be covered but it's fine the way it is also. ? Now that you have everything on how's the ammo belt to Ab button gap?

Looking good Nick. Just an FYI, The cover strip material should not extend past the edge of the armor. Keep up the good work

Looking good Robert . IF you don't mind me asking are you shooting for Expert Infantry or Centurion?

Anytime THT

Excellent, glad it helped.

Wear PPE (correct gloves) Bring a large pot of water to a boil. Remove heat or reduce to a simmer. Place object in water for 30-45 seconds. Remove, apply equal pressure by hand or using other object until desired shape is obtained. While maintaining shape place under cool water for 60 seconds Repeat as necessary.

We'll be here when you're ready

Looking good Martijn, you might want to set the tip screen material back just a bit. Here's some reference photos.