Harbinger[IPM] Posted December 3, 2017 Report Share Posted December 3, 2017 (edited) General Information Name: Brien Edick FISD Name: Harbinger 501st ID: 92802 Profile Page: http://www.501st.com/members/displaymember.php?userID=26568&costumeID=124 Garrison: Central California Garrison Mandatory Information Armor Maker: ANOVOS Helmet Maker: ANOVOS Blaster Type: Praetorian Blasters ANH E-11 Additional Information Height: 5' 7" Weight: 180 lbs Boots: TKBoots Canvas Belt: TKittell Gloves: Home Depot Hand Plates: justjoseph63 Electronics: N/A Neck Seal: ANOVOS Holster: ANOVOS Build Thread: https://www.whitearmor.net/forum/topic/43244-harbingers-first-build-anh-stunt-tk/ Armor Photos (Click for Full Size) Full Body Front: Full Body Back: Full Body Right: Full Body Left: Right Side Detail: Left Side Detail: Ab Button Detail: Helmet Detail Photos Helmet Front: Helmet Back: Helmet Right: Helmet Left: Helmet Hovi Detail: Helmet S-Trim Detail: Helmet Lens Color: Helmet Right Ear/Screw Detail: Helmet Left Ear/Screw Detail: Accessory Photos Belt Front: Belt Back: Thermal Detonator Front: Thermal Detonator Back: Neckseal: Hand Guards: Boots: Blaster Right: Blaster Left: Blaster D-Ring: Armor Detail Photos Thigh Ammo Right: Thigh Ammo Left: Thigh Ammo Rivet Detail: Sniper Knee Right: Sniper Knee Left: Cod Rivet Detail: Posterior Snap Detail: Interior Strapping: Known Issues (Centurion To-Do's) • Tighten Shoulder/Bridge gap (need new elastic) • Mic Tip Mesh • Re-paint Vocoder Details Action Shot! Edited December 3, 2017 by Harbinger 2 Quote Link to comment Share on other sites More sharing options...
Harbinger[IPM] Posted December 3, 2017 Author Report Share Posted December 3, 2017 Noticed the belt was a bit low after all the photos, so I added some Velcro: (Too lazy to put thighs on.) Quote Link to comment Share on other sites More sharing options...
magni[TK] Posted December 3, 2017 Report Share Posted December 3, 2017 Looking good! Best of luck Brien! Quote Link to comment Share on other sites More sharing options...
CableGuy[Admin] Posted December 4, 2017 Report Share Posted December 4, 2017 Looking great. Good luck, Brien. :-) Quote Link to comment Share on other sites More sharing options...
Shanester[TK] Posted December 4, 2017 Report Share Posted December 4, 2017 Very nice build. Best of luck! Quote Link to comment Share on other sites More sharing options...
TK8776 jgarrettg Posted December 6, 2017 Report Share Posted December 6, 2017 You did a great job putting that together Brien. Quote Link to comment Share on other sites More sharing options...
ukswrath[Staff] Posted December 7, 2017 Report Share Posted December 7, 2017 Hey Brien thank you for your EI application. CRL and EIB Application Requirements:All the required submission photos have been posted. Beautiful job on your build . Your armor meets all EIB requirements, Andrew and myself are delighted to welcome you to Expert Infantry. Congratulations Other-Armor Fit/Assembly: In this section we review observations made by your fellow troopers and ourselves. Some observations may lead to suggestions to improve the overall look of your armor and accuracy. If any suggestion affects any application, it will be listed separately in the above or below sections. Again, these are suggestions and recommendations. The accuracy is ultimately up to you. Your helmet Vcoder lines could use a little more definition as seen in the provided reference photo. We're recommending you touch up the following areas. Reference photo The Hovi tip screens should be a heavier weave. We're recommending you replace these Reference photo Next up is the shoulder bell gap. There should be minimal gap between the shoulder bells and chest/back plates. This may be a simple photo issue, if not do the best you can to bring these in as close as possible. Tightening the straps and removing any lower return edge tends to help the most. Reference phoito And finally, the right side of the sniper knee looks to be protruding out a bit. We're a little concerned it might get snagged on something. Centurion Suggestions: In this section we prepare you for your Centurion application if you choose to apply. If there were any areas of concern they would be discussed here. At this time we have nothing to add. That's it, great job. Hope to see you at Centurion. Quote Link to comment Share on other sites More sharing options...
CableGuy[Admin] Posted December 7, 2017 Report Share Posted December 7, 2017 Congrats, Brien. Good job. :-)Sent from my iPhone using Tapatalk Quote Link to comment Share on other sites More sharing options...
gmrhodes13[Staff] Posted December 7, 2017 Report Share Posted December 7, 2017 Congratulations and welcome to the ranks trooper Quote Link to comment Share on other sites More sharing options...
Harbinger[IPM] Posted December 7, 2017 Author Report Share Posted December 7, 2017 11 hours ago, CableGuy said: Congrats, Brien. Good job. :-) Sent from my iPhone using Tapatalk Thanks! You too Thanks everyone. Now on to L3. 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.