Sersanara Posted December 5, 2012 Report Share Posted December 5, 2012 (edited) Name: Sergio Sanabria ID: TK-3480 FISD Nick: Sersanara Garrison: Spanish Garrison Height: 1,74m Weight: 69 kg Armor: AP Helmet: AP Blaster: Custom built by Fernando M. Aranda (Antillis) Boots: TK Boots Neck Seal: Made by Oiftanker (Arron) Canvas Belt: Manufactured by TKittell (Robert) Holster: Made by TK-8280 (Bernard) Hovi-Mix: ssunky (Mark) Helmet Ears shall have three screws per side, one above and one below the ear bar and one at the base of the helmet. Ear bars should have four bumps only, not three. Traps/tears and tube stripes shall have the correct ANH TK details. Correct 'Hovi mic' aerator tips. Shoulder Straps No visible rivets are allowed. And others images Abdomen Plate Any gap between the ab and kidney plate shall be no more than 1/2" (12.5mm) wide. Any shims used to achieve this effect should be of a similar material and color as the ab and kidney plate. Shims shall fit flush and seams are allowed . Kidney Plate, Butt Plate A separate kidney plate shall be present, split from the butt plate. Belt Belt shall be canvas or canvas covered, leather and vinyl are not acceptable. There shall be three square buttons, one centered in the middle and one on each end of the plastic ammo belt.. And other images Thermal Detonator The thermal detonator needs to be attached via metal clips approximately 1" (25mm) wide, and shall be all gray without silver stickers or silver paint. Holster Holster shall be worn on the left and be attached to the belt from behind instead of front, with no loops covering the outside of the belt. The holster will be affixed with two fasteners at the bottom of the belt instead of none or four. These may be rivets, snaps, or Chicago screws. Others Blash Tech E-11 Folding stock (does not need to function). A real or replica ammo counter - based off of a Hengstler counter - shall be present. Two power cylinders on the magazine housing. D-ring mounted on the rear. Correct style scope. Scratch-built, resin cast, Hyperfirm rubber cast blasters shall have a total of 6 T-tracks on blaster (leaving the lowest row on the magazine housing side uncovered). If using the Hasbro E11 toy blaster and you cover all the rows of holes, the blaster will have 7 T-tracks total. But, if you want to have the correct number of T-tracks (6 total) with the lower row of open vent holes on the magazine housing side, then you shall cover the pre-existing rows of holes with T-tracks, and grind off the lower integrated T-track on the magazine housing side and drill a new row of holes in its place. No ESB/ROTJ greeblies are allowed on the blaster. Action Shot Best Regards. Sergio. Edited December 5, 2012 by Sersanara Quote Link to comment Share on other sites More sharing options...
Mogwai[TK] Posted December 5, 2012 Report Share Posted December 5, 2012 Looks good Great Work. But I think you need to do a Action Shot. Quote Link to comment Share on other sites More sharing options...
FunkyTrigger[TK] Posted December 5, 2012 Report Share Posted December 5, 2012 This is an excellent submission and complete with the EIB mods in comment form. The build looks great, as do you in your Armour. Well done there trooper. Quote Link to comment Share on other sites More sharing options...
Clamps[TK] Posted December 5, 2012 Report Share Posted December 5, 2012 Looking great Sergio. Excellent images and very well fitting build. Best of luck with your EiB approval, though I don't think you need any luck.... Quote Link to comment Share on other sites More sharing options...
Mongoose[TK] Posted December 5, 2012 Report Share Posted December 5, 2012 Looks good! Quote Link to comment Share on other sites More sharing options...
Rezablad3[TK] Posted December 5, 2012 Report Share Posted December 5, 2012 Very well done and clean build.... you've done a fantastic job with it. Good luck man, but like Charles said....doesn't seem like you need any... Quote Link to comment Share on other sites More sharing options...
Sersanara Posted December 5, 2012 Author Report Share Posted December 5, 2012 Initial post edited with more intro information and action shot. Quote Link to comment Share on other sites More sharing options...
captsafe66[Admin] Posted December 5, 2012 Report Share Posted December 5, 2012 Very Nice Build!! Good Luck Trooper!! Quote Link to comment Share on other sites More sharing options...
Clamps[TK] Posted December 6, 2012 Report Share Posted December 6, 2012 Sergio you may want to consider another action shot as the one posted is blurry with a busy background and will be more difficult to clean up for your EiB area shot. It'll be a good excuse to suit up once more to make you look your best. </my2cents> Quote Link to comment Share on other sites More sharing options...
Sersanara Posted December 6, 2012 Author Report Share Posted December 6, 2012 Another action shot SWAT pose Quote Link to comment Share on other sites More sharing options...
gmrhodes13[Staff] Posted December 6, 2012 Report Share Posted December 6, 2012 Looking good there trooper Quote Link to comment Share on other sites More sharing options...
TK Keith[TK] Posted December 6, 2012 Report Share Posted December 6, 2012 I like the SWAT pose. And congrats on the build-- it looks sweet and the armor seems to fit great! Quote Link to comment Share on other sites More sharing options...
Faie[TK] Posted December 8, 2012 Report Share Posted December 8, 2012 Nice build Sergio, good luck!!! Quote Link to comment Share on other sites More sharing options...
antillis[TK] Posted December 8, 2012 Report Share Posted December 8, 2012 Great Sergio, esta genial!!! Quote Link to comment Share on other sites More sharing options...
Locitus[Admin] Posted December 15, 2012 Report Share Posted December 15, 2012 Approved! Quote Link to comment Share on other sites More sharing options...
Faie[TK] Posted December 15, 2012 Report Share Posted December 15, 2012 Congrats Sergio, good job!! Quote Link to comment Share on other sites More sharing options...
gmrhodes13[Staff] Posted December 15, 2012 Report Share Posted December 15, 2012 Congrats, well done trooper Quote Link to comment Share on other sites More sharing options...
Mogwai[TK] Posted December 16, 2012 Report Share Posted December 16, 2012 Congrats Trooper! Quote Link to comment Share on other sites More sharing options...
Sersanara Posted December 18, 2012 Author Report Share Posted December 18, 2012 Thank you for the approval, and thank you all for yours comments. I'm Quote Link to comment Share on other sites More sharing options...
Mongoose[TK] Posted December 18, 2012 Report Share Posted December 18, 2012 Feels good doesn't it. Quote Link to comment Share on other sites More sharing options...
captsafe66[Admin] Posted December 18, 2012 Report Share Posted December 18, 2012 Congrats Trooper!! Quote Link to comment Share on other sites More sharing options...
Rezablad3[TK] Posted December 18, 2012 Report Share Posted December 18, 2012 Congratulations trooper....welcome to the ranks... Quote Link to comment Share on other sites More sharing options...
tigresa[TK] Posted December 23, 2012 Report Share Posted December 23, 2012 Enhorabuena colegaaaa!!!!!! Quote Link to comment Share on other sites More sharing options...
Dazauto[TK] Posted December 26, 2012 Report Share Posted December 26, 2012 Great job, congrats trooper Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.