Name: Sergio Sanabria
ID: TK-3480
FISD Nick: Sersanara
Garrison: Spanish Garrison
Height: 1,74m
Weight: 69 kg
Armor: AP
Helmet: AP
Blaster: Custom built by Fernando M. Aranda (Antillis)
Boots: TK Boots
Neck Seal: Made by Oiftanker (Arron)
Canvas Belt: Manufactured by TKittell (Robert)
Holster: Made by TK-8280 (Bernard)
Hovi-Mix: ssunky (Mark)
Helmet
Ears shall have three screws per side, one above and one below the ear bar and one at the base of the helmet.
Ear bars should have four bumps only, not three.
Traps/tears and tube stripes shall have the correct ANH TK details.
Correct 'Hovi mic' aerator tips.
Shoulder Straps
No visible rivets are allowed.
And others images
Abdomen Plate
Any gap between the ab and kidney plate shall be no more than 1/2" (12.5mm) wide. Any shims used to achieve this effect should be of a similar material and color as the ab and kidney plate. Shims shall fit flush and seams are allowed .
Kidney Plate, Butt Plate
A separate kidney plate shall be present, split from the butt plate.
Belt
Belt shall be canvas or canvas covered, leather and vinyl are not acceptable.
There shall be three square buttons, one centered in the middle and one on each end of the plastic ammo belt..
And other images
Thermal Detonator
The thermal detonator needs to be attached via metal clips approximately 1" (25mm) wide, and shall be all gray without silver stickers or silver paint.
Holster
Holster shall be worn on the left and be attached to the belt from behind instead of front, with no loops covering the outside of the belt.
The holster will be affixed with two fasteners at the bottom of the belt instead of none or four. These may be rivets, snaps, or Chicago screws.
Others
Blash Tech E-11
Folding stock (does not need to function).
A real or replica ammo counter - based off of a Hengstler counter - shall be present.
Two power cylinders on the magazine housing.
D-ring mounted on the rear.
Correct style scope.
Scratch-built, resin cast, Hyperfirm rubber cast blasters shall have a total of 6 T-tracks on blaster (leaving the lowest row on the magazine housing side uncovered).
If using the Hasbro E11 toy blaster and you cover all the rows of holes, the blaster will have 7 T-tracks total. But, if you want to have the correct number of T-tracks (6 total) with the lower row of open vent holes on the magazine housing side, then you shall cover the pre-existing rows of holes with T-tracks, and grind off the lower integrated T-track on the magazine housing side and drill a new row of holes in its place.
No ESB/ROTJ greeblies are allowed on the blaster.
Action Shot
Best Regards.
Sergio.