gmrhodes13

Depending on your frame you may not need to size down any pieces, I am thin and just added some foam in places to stop it moving around, you ideally want to keep a consistent sizing/look to the costume rather than sizing down to your frame (depending on how big the pieces are of course). I don't have any gap between my boots and the shins, I have a piece of elastic looped through the top of the boots which goes up inside to the shin and held with snaps, helps to keep the shins down and stop rotation.

Hello and welcome aboard

Hello and welcome aboard, as mentioned there is no assembly guide most of the info you will find in build threads, lots there with different ways to assemble and strap so have a good look through. I'm not sure what size Imperial Boots goes up to but you may also be able to reach out to CROWSPROPS on Facebook, he does custom sized boots, to sure about FOTK though. Good luck with the research.

Hello and welcome aboard

Very nice, I also use the momentary switches, can fit them in lots of confined places, great for small blasters. Looking forward to the progress

Very nice, I add a 3.5mm jack to my blasters that are wired along with the speaker, normally fit them underneath the barrel at the back behind the handle then your hand covers the wiring, so they aren't seen, allows you to run a cable from the Aker amp down your arm to the blaster, nice and load for conventions.

Gloss white Satin Black Silver

You will need to supply a link to your 501st profile https://www.501st.com/members/displaymemberdetails.php?userID=6393

Hello and welcome aboard

Looking forward to seeing the progress, good luck.

Hello and welcome aboard, some great info can be found in the "Getting Started" section, also check out some of the builds, makers names are usually in the build titles Good luck

Hello and welcome aboard

Just allows the sandpaper to glide a little easier and doesn't clog as much as dry sanding, I know what you mean about sanding your fingerprints down, here's my fingers after wet sanding my Sithtrooper armor, you don't realise the skin is going until it's too late

I hate the prep work with 3D prints but it's worth it in the end. I found using wet and dry sandpaper and water with a little soap detergents really helps.

Hello and welcome aboard, good luck with the build

Hello and welcome aboard, great to see you have been doing some research. For T-21 build you could post a build thread here.https://www.whitearmor.net/forum/forum/120-minimag-ptl-missile-launcher-t-21-rt-97c-mg-15/ Looking forward to seeing your progress.

Awesome, looking forward to the progress

Very nice looking forward to seeing these put together

No it doesn't, most of the legion web department are working on forum upgrades so I doubt you'll see a shift to Discord any time soon.

Congratulations trooper

Hello and welcome board, good luck with the build

Looking forward to the progress, when in doubt there are some great reference images in the "Gallery Sections", Good luck with the build

Nice work

Awesome news, nothing better than BBB's, now the fun begins, good luck

Congratulations and welcome to the ranks trooper