Jump to content

TK-24271 Requesting ANH Stunt Centurion Status [TM][260]


Chip

Recommended Posts

Name =                                    Steve Tennison

501st TK ID =                           24271

FISD forum name =                  Chip

Garrison =                                UK Garrison

Expert Infantry Request Thread =     http://www.whitearmor.net/forum/topic/36085-tk-24271-requesting-anh-stunt-eib-status-tm-542/

 

EIB Comments:

 

 

 

Other-Armor Fit/Assembly:

In this section we will discuss observations made by your fellow troopers as well as ourselves. These may contain suggestions to improve the overall look of your armor. Unless stated in the above or below sections, these suggestions are not required.

Very tidy build indeed, if there were anything, and it would be picky, may we suggest you take a small amount off the tops of your front thigh cover strips (that is only if it not just the camera angle that makes them look longer than the thighs).

From a point of accuracy, and again these are a little hard to tell from the photo, but make sure those screws in your Thermal Det are pan head, we just cant quite make it out.

Good paint job on the helmet, perhaps see if you cant tidy up the black outlines on the Traps as they are a little thick in areas.

 

Centurion Suggestions:

We try to spot all that we can and mention it here, but the final Centurion accuracy is up to the trooper.

You got this, close up the gaps between Kidney and Ab plate, make sure you have all the required photos posted up and re check the Level 3 requirements in the CRL.

  • Thigh coverstrips have been trimmed for comfort
  • TD screws are pan head have included a close up shot where the slot can just be made out
  • Helmet black lines thinned out
Mandatory Information
  • Armour Maker =           TM
  • Helmet Maker =            TM
  • Blaster Type =              Doopydoos Full Resin
Optional
  • Height =                       6' 2” / 185cm
  • Weight =                       15 Stone 0 lbs / 95 Kg
  • Boots Maker =              Brogini
  • Canvas belt =               TM
  • Hand Plates Type =      Painted Latex from ISD
  • Electronics =                 TRamp
  • Neck Seal Type =         ISD
  • Holster Maker =            ISD
Sample Application Photos

 

Armor Photos

 

Full Body Front

Body%20Front.jpg

 

Full Body Back

Body%20Back.jpg

 

Full Right

Body%20Right.jpg

 

Full Left

Body%20Left.jpg

 

Right Side Detail

Body%20Right%20Detail.jpg

 

Left SIde Detail

Body%20Left%20Detail.jpg

 

Armor Details

 

Gloves / Hand Plates

D272272F-FB21-4257-8C5B-53F071E7F7E9.jpg

 

IMG_3128.jpg

 

Shoulder Bridge Back

IMG_3119.jpg

 

Thigh Pack Attachment

IMG_3127.jpg

 

Sniper Knee Attachment

Sniper.jpg

 

Drop Box Back

IMG_3112.jpg

 

Crotch/Butt Detail

IMG_3116.jpg

 

Helmet Detail Photos

 

Front

IMG_3101.jpg

 

Left Side

Helmet%20Left.jpg

 

Right Side

Helmet%20Right.jpg

 

Back

DDCF638C-6E25-40AB-934E-7E36EA22E857.jpg

 

Hovi tip detail

IMG_3105.jpg

 

Lens color (Backlit if necessary)

IMG_3107.jpg

 

Accessory Photos

 

Ammo belt

9E1DA776-B391-49CA-B6BB-3B0672F9B154.jpg

 

Neckseal

F4EB3316-125B-45BC-AD13-CC0B53FF772E.jpg

 

Blaster left side

IMG_3129.jpg

 

Blaster right side

IMG_3130.jpg

 

Thermal detonator back

IMG_3110.jpg

 

FF837881-9A92-4EB0-9C88-EE135A555CD6.jpg

 

Action Shot

20160214_134321.jpg

 

Optional

 

Interior Strapping

IMG_3120.jpg

 

Abdomen Detail

IMG_3115.jpg

 

--------------------

Link to comment
Share on other sites

Hey Steve thank you for your Centurion application. Before we get started please post the following pictures.

 

An unobstructed view of the kidney/ab rivets (exterior) and forearms (wrist side). 

 

Thanks brother

Link to comment
Share on other sites

Hi Steve, thank you for your patience and Centurion application. Let's get you approved.


CRL and Centurion Application Requirements:


All required photos are present. Your armor meets the requirements for L3. Sly and self would like to congratulate and welcome you to the Centurion ranks. Great job.        :duim:


 


Other-Armor Fit/Assembly:


In this section Sly, myself and sometimes your peers will suggest corrections that will enhance the look and accuracy of your armor. None of these suggestions will effect your Centurion application but are recommended. We're suggesting you glue your drop box strap to the waist belt to help keep it aligned with the ammo belt. With the belt off they clearly move out of position. Your ab buttons are a bit large but not a deal breaker. And finally, we suggest you reposition your thighs higher, about 1" if possible, would solve a couple fitment issues we see.   


 


Excellent! job on your build. Congratulations  :salute: 


Link to comment
Share on other sites

  • 3 months later...
  • 3 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...