Leaderboard
Popular Content
Showing content with the highest reputation on 08/13/2025 in all areas
-
Thanks again Glen! I should get residual payments for each link from you LOL2 points
-
Thanks for the suggestion! Putting a piece of foam there works *fantastic*! You can't see it when it's on, and it leaves just enough of a gap so the return edge doesn't touch my back.
1 point -
Here is where the trim line would need to be to make it L3 compliant.1 point
-
Thanks mate, so it's really all about not having the gaps vs something fundamentally wrong with it being an extra bit. As long as it visually looks like its a complete continuation of the helmet I'm going in the right direction? Very helpful, thank you1 point
-
Hows this look: might make the centre spine a little thinner on the left side to make the left top trap bigger in area. I had used the base print file so theres an extra 3mm width over all that needs to be taken back to accomodate the thickness of the plastic.1 point
.thumb.png.69856e02550a2e6d07e44a2b1bda020c.png)