Leaderboard

I used the edge trim I had purchased, and based on the image of the trim on the helmet reference on the R1 TK gallery page, I started the trim on the back of the neck side and overlapped it in a similar fashion as the image in the gallery.

I think the wording must be based on Non saga can't, be used in general on say one of the weathered R1 TK's because 501st members were in scenes with OT armour Non saga episodes of other series. I think you still need to add the words In "Rouge 1" Non saga for total clarity.

Look fine, many armors won't accommodate this but screen references show 1 large tab and 4 1/2 to 5 small tabs, my ATA only accommodates 2 1/2 tabs, there is no requirement. When adding glue I places chest/back strapped over a box and align the fronts so the rear covers the backplate. Also not a requirement but you can cut off (or in half) the big tab on the rear, screen suits didn't have them From the DO's guide: "NOTE: As seen in the photos below, there are no large tabs on the rear of the shoulder bridges. This is not specifically mentioned in the CRL, but removing them is highly recommended if possible." Also "Level 3, they shall free float in the back, be glued in the front and need to be held down in the back via a white elastic band to the white fabric/elastic chest/back connection."

Nice work, looking good

Oops will fix that, I remember that and thought I’d left it in. It is there, lvl 3 as it was in the original. All the others have been addressed. Biggest change was moving the cracking text into general so it's not constantly repeated, though shoulders explicitly say no cracking. Blaster flashlight added "if fitted" as per original. Belt updated to match the current R1 CRL.

Done!

I'll just put this right here... As I've said, I want to contribute to the group. If this belongs elsewhere, I'll post it there. I'm on a quest to shoot for screen quality of my build. Oh... and I really like nice sharp painted edges and perfection, so I made a rank insignia STL with all the painted parts extracted. It makes painting this quite easy! The final product will fit Big Fred's armor... but I'm sure it could fit GA's set as well. Enjoy! Here's the link to the STLs: http://www.kivaspirit.org/ImperialCommando/ImperialCommandoRankInsert.zip

The curved lower corners aren't quite as full as you have trimmed it but I doubt it will be an issue for base approval Reference