Leaderboard

Worked on cod and butt plate. Placed the two snaps in the butt and the one (unpainted) rivet in the cod.

and of course...

Welcome aboard!!

ROTK helmet is what I used that was a rotomold. Just messing around in the shop

I used epoxy putty to fill in the gaps in the joints, then used polyester putty to create an even smoother surface. This was my first experience using putty, and I ended up ordering the wrong type of putty when I ordered it. What arrived at my house was lacquer putty, not polyester putty. I looked up the instruction manual and watched YouTube, and there didn't seem to be much difference in how they were used, so I used them as they were. In other words, this image is of the lacquer putty. I'm very worried about the finished product because I have nothing to compare it to. But I'm going to keep using the file to smooth out the surface. This is an image using epoxy putty. This is Cemedine.CO epoxy putty for plastics. For the lacquer putty, I used Tamiya putty basic type. Starwars Celebration Japan 2025 will be held from April 18th. Are there any of you seniors who will participate? I will participate in the event. It was my dream to participate with armor approved by the 501st Japan Chapter, but unfortunately I will not be able to make it in time. However, I am very excited to be able to exchange SW culture with many people. I have also prepared my first SWAG. Would it be possible to post a link to my SWAG X here?

Ciao Antonio, welcome to FISD!