Leaderboard

Name : Torben ID : TK-19525 FISD Forum Name : Tall_Trooper Garrison : German Garrison 501st Link : https://www.501st.com/members/displaymemberdetails.php?userID=36777 Social Media Consent : Yes Height : 195cm Weight : 78kg Armor : RWA Helmet : RWA Blaster : unknown Boots : Keeptrooping Belt : RWA Hand plates : ArtneoES A big thank you to @Morgi and @Ripper_L who helped me with the photos and also took them --Full Body-- --Amor Details-- --Helmet-- --Accessories-- --Blaster--

Agreed and will note for the troopers who help me take the final photos. I do intend to release the visor files and a downloadable template for the pauldron for free to the Detachment once the CRL is live.

Finally found time to put the whole costume on and get some decent photos shot by @KC Grim. Please let me know any additional feedback you have before proceeding. I plan to add some light weathering to match reference before submitting final photos for the CRL, but want to ensure everything else looks good in advance. Thank you!

Even Lord Vader approved my armor. ComiCon Stuttgart was a blast. Exhausting but so much fun.

I decided to drill out the recessed sections on the tube stripes and add a blue section underneath. I drilled them with four or five holes using a Dremel. I then used the same bit to remove the small amount of remaining material between the holes. Afterwards, I used two files to sand down the openings. I then used 400 grit sandpaper to clean up the openings. In order to drill the final three stripes at the rear of the tube, I removed the clamps that snap the front of the helmet to the back of the helmet. They have two small screws and are easily removed. I also hollowed out the inside of the helmet under the stripes so that eventually I can lay the blue underneath and have it lay flat behind the hollow stripes. I still have a little cleanup but they are 95% finished.