Leaderboard
Popular Content
Showing content with the highest reputation on 07/31/2023 in all areas
-
Looks great, the only issue I can see is the closure strap is a little wider compared to the screen references Much improved on the puffy look pauldrons1 point
-
i think that is almost perfect Sent from my SM-S918U using Tapatalk1 point
-
@Sly11, @gmrhodes13, @revlimiter, @Chemi what do yall think? Flat without any puffiness to the pauldron and the attachments are not evident on the left side.1 point
-
A few approved RS centurion application references for you1 point
-
If I understand your situation, you want to display the back and chest piece with shoulder bells on a bust? Just cut the elastic where the chest meets the abs and butt plate, then slip the top half over bust.1 point
-
Of course I’m assuming you’ve marked 10mm for on the return edge. If it’s 10mm from the other edge though than that’s right. It just needs to be 10mm from whatever the hard edge will be. Sent from my iPhone using Tapatalk1 point
-
I’d say it depends on if you plan on further trimming along this edge (marked in red) If you do plan to trim that off, then I think your marks are good. If not then you’d probably need to move them to 10mm from the actual edge of the plastic. Sent from my iPad using Tapatalk1 point
-
These brackets are also on the back plate to kidney. Adjustable spanner and screwdriver1 point
-
You have to remove the brackets to separate the chest to the abdomen, same on the back
1 point -
Gloves - check ✅1 point
-
Found a few posts in the Anovos build group on Facebook, unfortunately no finished images https://www.facebook.com/groups/838545079553903/search/?q=too tall And another Here's an extended kidney
1 point
