Leaderboard

After a few minor touch ups I am pretty happy with how the stripes came out. Now for the tube stripes...wish me luck. Thanks, M

I got busy and managed to not update things here yet. This is the tiny circuit board inside the Disney blaster. It's about 20mm wide which juuuuust fits inside my QD blaster's small inner recess. Not sure if this diagram would be helpful to anyone else in the future, but I referred to it a lot while rewiring the board. And just like that, the old handle is off. It was almost that easy. I used a dremel cut off wheel and sliced through about half of one side, waiting to hit some sparks. No sparks ever appeared, making me think that only glue held the handle in place. Sure enough, there weren't any pins. I snapped the handle off easily by hand after slicing what I sliced. I think this may have broken at some point in the future anyway. I'm amazed it was only glued on. Also, pretty happy with the low amount of gouges I managed to make. They'll be easy to fill. Bolt cut. This gives me access to allow the handle to be bolted in place. The inner plastic on the QD is SOOOO thick. It just insane. Not letting any grass grow under my feet. The handle bolted on easily for a test fit. About 20 minutes of careful measuring followed by two holes and a slot for wires. My blaster was only without a handle for a half hour. Front bolt attachment. SUPER easy access with this nice big hole. I'll also fit the pew-pew brain in this hollow. The rear bolt is a lot more challenging to get to, but a rounded end hex key makes easy work of it. The angle is just right to let things spin and tighten up. This grip is so pretty! So very very pretty. Even without pew-pew noises, this is a solid upgrade already.

Thanks for the warm welcome everyone. Thank you for the info gmrhodes13. I’m sure I will hit you up for tips Helotech. Hi Sly, I am up in Hervey Bay with Baytrooper, Bigdub and Wolf