Leaderboard

Looking good trooper! If I was your GML, you would be approved as is. A few little things The cover strips on your biceps are a tad too long. Trim them to be in line with the bicep itself. Your forearms seem a bit long for your body. I can especially notice this when your handguards slip into them a bit in your "at attention" picture Your thighs could probably be pulled up a tad.

Paldron by Veeds, leather or pleather mp38/40 magazine holders (thanks for the link Joseph) Magnets for the "cricket shins" 'TM - slow boat from china finally got here

Looks pretty nice, there, trooper! The ammo belt/canvas belt should be directly below the ab buttons- yours is lying on top of the bottom. As to modifying your own posts, there's an "Edit" button at the bottom of your post, and if you just need to continue adding, you can always just reply to the thread.

Happy to help out

Congratulations, Justin! Well done.

FYI: I queried TK Boots on Tuesday for size 11's and they indicated they still have a few size 12 left ("We currently have 12C's and only one or two pairs of 12D in stock"). Based on their recommendation, I went to a local store and tried on a size 12 men's shoes with athletic socks on and I think that (and/or inserts) will work fine. Get em while you can.

Not much to say but I’ve been trimming the excess plastic away. Ive gotten a struck of luck and I’ve hired again and now work has been consuming my time, but whenever I get te chance trim seal at least two or three pieces and settle everything down for later. I have ordered the frown paint so it should eventually get here. I haven’t painted the vocoder either yet because I’m procrastinating excessively, so yeah, I will eventually get to the handpainting and placing the decals on the helmet, probably at all the same time once the frown paint gets here. In terms of fitting the armor is the scariest part, but I’ve got back up from fellow troopers and I’m whenever I get the chance I work on a RO Death Trooper for an inspiring 501st member and I’m more than willing to and get it up to standards... and I’ll probably end up getting one soon, but I’ve gotta tackle a jango fett first; and most importantly the TK itself. I still have to order the boots, canvas belt and the blaster and a set of welder lens for the helmet - which I’m also considering on painting the inside black and go with a cool padding and fans, but priorities first... The white armor 4326 out

Bicep and forearm gap fix. First I started with bringing the top of the bicep to be just covered by the bell Next I cut 3 4 inch nylon pieces and added my snaps to them and glued them in place and placed a magnet to hold I than placed the bell back over the bicep to mark the location where I'll be glueing the male snaps directly to the bell I marked them down slightly lower as I want the nylon to have a slight bend to it and not stress the snaps that they will pop off if I move my arm. And held in place on the back by a magnet And allowed to dry for 24 hours

Looking forward to seeing some pictures of them

Congratulations trooper

Just got my Gaskets, harness, and Neck Seal from Geeky Pinks and wow! I'm so glad everyone convinced me to do so. They are absolutely amazing in quality and comfort! @Soulartthank you so much for your service! I can't wait to get my armor and get going with this!

The build is coming along nicely. Those ear gaps are actually quite screen accurate. Keep up the good work trooper!

As mentioned by the fine gentleman above me, I will just be repeating what they said.. so.. ^what they said lol. But you are looking like you made some great progress. keep it up!

Updated