Leaderboard

I had the exact same issue going for EIB. Here's my before and after: There were two things I did to fix it. First I tried just bending out the metal so that the donut faces outward instead of upward. You very well might be able to get away with just doing this. However for me it made the TD stick out from my belt too far so in the end I removed and cut off around an inch of metal down to the second screw hole. Turns out my metal clip were longer than I needed. I had to re drill a new hole since once was cut off on each piece

Nice work trooper, appears you are missing an action photo, (pretty sure you had one in your folder previously) You may also want to check your detonator measurements, very little room between the end caps and control panel, end caps look a little wide, control panel usually stops in alignment with the screws, reference posted bellow You could also remove a little section of wire on your blaster, it is very bunched up. Recent Expert Infantry application #1087 References Please note these are just suggestions the DO's may or may not require the changes Good luck with your application trooper

Thank you both!

@Cybergrunt Can confirm, Cybergrunt served as my armorer, in person, and always helped with smaller issues on call. He not only assisted with all the repairs, brought materials, and instructed on further care, he also helped me reach Expert Infantry Status. Overall, time spent repairing armor and making sure it was up to EIS standards has collected a total over 6 hours. Thank you so much for everything, Bill (TK-20177).