Leaderboard

Some helmets had a small rise in the middle of the brow trim I do prefer the straighter look though.

Made some progress today, well atleast I think I did haha. I started by finishing the brown trim. It’s not secured yet just sitting in place. I then trimmed my ear pieces down and got them ready for the next step of forming them. BUT first I wanted to make sure this is lining up good before doing so. I switched from clamps to 2 screws and a small bolt to hold it in place for ear trimming. I have a bigger head so trying to plan for that. I plan on trimming the bottom out soon after the ears are done aswell. I am trying to make room because I’d like to add padding and a fan if possible, open to all feedback , as always , appreciate everyone’s time and input.

Hi Lucas. I will be the DO reviewing your application. Before I begin, could you please add a few photos for me? 1. I will need a photo showing the wrist section of your forearms. The one you have in the application is of the elbow side of the forearm. I need a photo from this side as shown below. 2. Could you please also add a close up view of the ab and kidney plate rivets on the left side? Again, similar to the one in the photo below. 3. A photo showing your helmet viewed from behind. Thank you.

A few things you may want to address before the DO's get here. Swap this snap, flat side faces out Looks like you have taken off too much material off from your large ab plate Note the area around the base, yours is missing You have some paint on your gums, Frown is painted gray and does not leave the teeth area. Also if your tube stripes are decals and recently applied you may be able to remove them on your right side (put tape on top of them, carefully lift, then replace) Ideally, the tube stripes are positioned approximately a pencil width from the side of the cheek. My internet is not allowing all your images to load, I'll try have a look if there is anything else needed

Links updated. Stormtrooper blaster sound effects links: Stun http://play.starwars.com/starwars_soundboard/asset/audio/BSR_blasters/blast_09.mp3 Kill http://play.starwars.com/starwars_soundboard/asset/audio/BSR_blasters/blast_10.mp3