Leaderboard

First enhancement, replace the solid resin detonator with an accurate, two piece 3D printed detonator. The model came from here on the FISD forum. It is sooo much lighter than the resin. Painting the tube and the enclosure using the Behr satin black and gloss white:

Looking zoomed in to the promo image, the waist band and front panels are defiantly leather. The red border trim matches the trim on the hips. The hip panels do not appear to be leather but harder to tell. The backing behind the 2 front panels looks fabric, something like a raw silk or taffeta maybe. To get that nice clean fold on the back I doubt it would be leather as the drape is worng. I can also see a bit of a point at the front in the promo. So this makes me think it's less of a Kama more of a skirt, with the two front leather "flags", leather wrap and then a padded panel on the hips.

Also looking at that promo image we would want to add the ribbed texture to the under suit, either at level 2 or 3. The neck section is black with matching texture, https://i.imgur.com/BxLg18K.png this confirms black to me. The neck seal texture would be a level 2/3 thing for me.

This CRL is now live: https://crls.501st.com/fisd/captain-enoch The new home for Captain Enoch as seen in the Disney+ series Ahsoka This thread is for the creation of the CRL for this costume, please keep all discussion relevant to the main goal. As this armour has similarities with elements from the Night troopers we will be able to reuse some of the work down there: https://www.whitearmor.net/forum/topic/53884-welcome-to-the-night-trooper-resource-thread-for-crl-creation/

I appreciate you and the FISD being patient and not giving up on helping me!?

Approved!!

4/15 preapproval troop (GCO approved) at Randall Children's Hospital, Portland, OR: Wore the costume for about 1.5 hours, walking for most of it. Overall went very well. Learned that I have a few things that need adjusting.

I think the trousers are burgundy like the top, this image shows it If the gloves are the same as the rouge one, should there be decorative stiching at the index finger for like Level 2 or 3? Also the hand grips of the blaster seems to be gold as well.

Added General Construction Notes, which covers some general things like no 3d print lines, damage and weathering must match the references.

You can use a razor blade to make the corners angled if you wish. It's very easy and pretty self explanatory once you do one. Just put the blade at the angle you want and then press. It'll go through the top and self-stop when it hits the armor below. Just keep your fingers out of the way. I'd do the top corner at the very least. It looks pointy right now.