Aradun[TK] Posted November 26, 2020 Report Share Posted November 26, 2020 I need a little advice for a Centurion requirement. I bought my armor from a retired Garrison mate. He did an incredible job on his build and built most of it to L2 and L3 specs, but I’m concerned about the following requirement for Centurion: “The corners of the plastic ammo belt shall be trimmed at a 45 degree angle that that meets the outer edge of the cloth belt.” As you can see from the photos below the corners as currently trimmed fall just short of meeting that requirement. You can see in the photo my pencil line, which marks where I’d need to trim the ammo pack in order for it to meet said requirement. Would this solution work or is there another work around? Quote Link to comment Share on other sites More sharing options...
magni[TK] Posted November 26, 2020 Report Share Posted November 26, 2020 Those look so close I wouldn't worry about it. I'd recommend wiping that pencil off and go have fun chasing Rebels and EIB certification 1 Quote Link to comment Share on other sites More sharing options...
gmrhodes13[Staff] Posted November 26, 2020 Report Share Posted November 26, 2020 They are pretty darn close, I would suggest leaving them for now and see if the DO's address them in your applications 1 Quote Link to comment Share on other sites More sharing options...
Aradun[TK] Posted November 26, 2020 Author Report Share Posted November 26, 2020 Sounds advice gentlemen. Will do. 1 Quote Link to comment Share on other sites More sharing options...
TKSpartan[Staff] Posted November 26, 2020 Report Share Posted November 26, 2020 8 hours ago, AradunFF said: I need a little advice for a Centurion requirement. I bought my armor from a retired Garrison mate. He did an incredible job on his build and built most of it to L2 and L3 specs, but I’m concerned about the following requirement for Centurion: “The corners of the plastic ammo belt shall be trimmed at a 45 degree angle that that meets the outer edge of the cloth belt.” As you can see from the photos below the corners as currently trimmed fall just short of meeting that requirement. Hi Dennis. If I can make some comments about. The pencil marked area for trimming is just right to meet the L3 requirement , Reference Images I would suggest also to reduce the 3 square buttons return edge to make then more flat and move then closer into the belt, as the references. Reference Images 1 Quote Link to comment Share on other sites More sharing options...
Aradun[TK] Posted November 27, 2020 Author Report Share Posted November 27, 2020 Thanks Mario! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.