agm.bobafett[501st] Posted August 21, 2017 Author Report Share Posted August 21, 2017 (edited) Goodnight Yes it's correct,Modify it last Saturday,The companions warned me of the errorI send the photos with the change Thank you Edited August 21, 2017 by agm.bobafett Quote Link to comment Share on other sites More sharing options...
ukswrath[Staff] Posted August 21, 2017 Report Share Posted August 21, 2017 Thank you Quote Link to comment Share on other sites More sharing options...
ukswrath[Staff] Posted August 22, 2017 Report Share Posted August 22, 2017 Hi Antonio, thank you for your EIB application. Let's take a look. CRL and EIB Application Requirements:All the required submission photos have been posted. You armor displays and the required components for L2. Andrew and myself would like to welcome you to the rank of Expert Infantry . Excellent job Other-Armor Fit/Assembly: In this section we review observations made by your fellow troopers and ourselves. Some observations may lead to suggestions to improve the overall look of your armor. If any suggestion affects any application, it will be listed separately in the above or below sections. We have a few areas to go over here so let's get to it. Starting at the top, it looks as if you cut the shoulder covers too short on the back side. There should be a tapering off of the cover where your's appears to be missing. It's recommended you repair or replace these. Take a look at the reference photos below. Reference photos. There should be minimal gap between the shoulder bells, chest and back plates. We're recommending you tighten the connecting straps and possibly remove more lower return edge allowing the bells to move closer to the chest and back plates. Reference photo Chest plate should lay flat against the ab plate. Not a big deal but the chest plate should be positioned closer to the ab. Tightening the straps between the two should remedy this. Reference photos Calf closure cover strip placement. As illustrated in the reference photo below the armor halves do not overlap and half the cover strip should be connected to the armor while the other half floats, essentially covering the opposite half of the shin armor. The arrow represents the edge of the armor in relation to the cover strip. It is recommended the cover strip be moved over. We'll talk about the over lapping armor in the Centurion section. Reference photo Centurion Suggestions: In this section we prepare you for Centurion. If there were any areas of concern they would be discussed here. One area of concern is the helmet decals. The CRL states for level three certification (if applicable): "Tears/traps shall be hand painted or use decals that emulate hand painted (with correct ANH TK details)." Yours will need to be replaced before applying for Centurion. Reference photo/s Drop boxes not alignment with the ammo belt. The CRL states: "For level three certification (if applicable): Drop boxes are vertically aligned with the end of the ammo belt with minimal gap between belt and box." Simply gluing the drop box strap to the cloth belt usually remedy's this issue. Reference photo As mentioned in the EIB suggested section the CRL states: "For level three certification (if applicable): Lower legs must be constructed using the butt joint and cover strip method. Overlap construction is not allowed." This applies to the rear also. The calf halves should butt up against one another with the cover strip over the joint. Reference photo That's it Antonio. great job on your armor. Hope to see you at Centurion. 1 Quote Link to comment Share on other sites More sharing options...
gmrhodes13[Staff] Posted August 22, 2017 Report Share Posted August 22, 2017 Congratulations and welcome to the ranks trooper Quote Link to comment Share on other sites More sharing options...
magni[TK] Posted August 22, 2017 Report Share Posted August 22, 2017 Congratulations Antonio! #750 is a easy one to remember! We're 3/4 of the way to 1000 with your approval! Well done! 1 Quote Link to comment Share on other sites More sharing options...
pistolero[TK] Posted August 22, 2017 Report Share Posted August 22, 2017 Antoniooo! Bienvenido al Olimpo de los expertos!! Good job trooper! Quote Link to comment Share on other sites More sharing options...
agm.bobafett[501st] Posted August 22, 2017 Author Report Share Posted August 22, 2017 Thank you, I will continue working on the armor to reach centurion level. I will take into account all your observations Best regards 1 Quote Link to comment Share on other sites More sharing options...
acetilacetato[TK] Posted August 22, 2017 Report Share Posted August 22, 2017 Congrats Antonio. You have to make some small changes. Welcome as EIB.Enviado desde mi SM-G920F mediante Tapatalk Quote Link to comment Share on other sites More sharing options...
Traumtrooper[TK] Posted August 22, 2017 Report Share Posted August 22, 2017 Welcome Antonio!!! And congratulations!!!Enviado desde mi iPhone utilizando Tapatalk Quote Link to comment Share on other sites More sharing options...
Sly11[Admin] Posted August 22, 2017 Report Share Posted August 22, 2017 Congratulations!! Quote Link to comment Share on other sites More sharing options...
toniltd[TK] Posted August 22, 2017 Report Share Posted August 22, 2017 Congratulations Antonio, congratulations for your new rank, with a few modifications you will get the centurion level. Welcome trooper Quote Link to comment Share on other sites More sharing options...
agm.bobafett[501st] Posted January 17, 2018 Author Report Share Posted January 17, 2018 i go Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.