PGHtrooper21 Posted October 29, 2015 Report Share Posted October 29, 2015 What is the measurements for cutting the 45 degree corners on the waist Belt? I saw a pic reference a few weeks back and I have been trying to find it? Thanks. Andy Quote Link to comment Share on other sites More sharing options...
gmrhodes13[Staff] Posted October 29, 2015 Report Share Posted October 29, 2015 (edited) Edited January 8, 2021 by gmrhodes13 photo updated gmrhodes13 2021 Quote Link to comment Share on other sites More sharing options...
PGHtrooper21 Posted October 29, 2015 Author Report Share Posted October 29, 2015 Thanks!!!! Andy Quote Link to comment Share on other sites More sharing options...
wingnut65[Staff] Posted October 29, 2015 Report Share Posted October 29, 2015 And... The end of the belt should end up being 3" (76 mm), the same width as your belt. Correct me if I'm wrong, but if the belt is different than 3", the cuts will need to be adjusted slightly to match. Quote Link to comment Share on other sites More sharing options...
I'm Batman[501st] Posted October 29, 2015 Report Share Posted October 29, 2015 Yeah, the CRL used to stipulate specific measurements similar to what Q posted above (or was at least spoken of a lot - I remember seeing 10/13 going around a lot), then they changed it in the last 12 months or so to just 45 degrees. 12/12 would be a good start, but could be adjusted slightly to look better against the belt. Quote Link to comment Share on other sites More sharing options...
Locitus[Admin] Posted October 29, 2015 Report Share Posted October 29, 2015 Your best bet is still always to "make it look like the originals". Real belt on top: http://www.whitearmor.net/forum/gallery/image/815-utilitybeltcomparisonanhontop/ 2 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.