Jump to content

Doopydoo full resin E-11 scope rail


Recommended Posts

Just built my Blaster, and its awaiting painting. for the Scope rail I bought a strip of 2mm Steel (20mm wide) from a local DIY store. I then used a dremmel and a vice to make the rail. I was going to use Alumininum but was a bit worried about it sagging as I could only get 2mm.

Edited by mondas42
Link to comment
Share on other sites

Go to the metal yard fence section of your home store. In this area, you will find support bars (usually displayed vertically in a tube) that get woven into the fencing to give it support. They are about 5/8" wide and 1/8 thick.

Link to comment
Share on other sites

wrap some copper ground wire from coax electrical cable around a piece of 1" pvc. you have to look at photos of a real sterling to get the proper spacing and

angle, and number of loops.

 

I use 3/4" x 1/8 aluminum flat bar from lowes. for sightrails.

Edited by TK Bondservnt 2392
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...