fieldmarshall
-
Posts
581 -
Joined
-
Last visited
-
Days Won
31
Content Type
Profiles
Forums
Gallery
Articles
Media Demo
Everything posted by fieldmarshall
-
Started listing alot of the individaul parts that make up the e11 assembly
-
not anytime soon gotta finish the dh17
-
-
I did shorten the smaller springs length to help with re weenie it doesn't show and makes things smoother.......... after all its not returning to bolt blow back
-
-
Spring first then the 5/32 x3/8 dowel
-
BOLT AND SPRING ASSEMBLY
-
Check the mag hole in the tube if there is any hang over trim it with a dremel or a file so it will not interfere with the mag
-
your can pull it up really tight for a seamless fit.... any small seem can be filled before painting ..
-
Mount to my alum tube body is easy,,,,
-
Special note !!! make sure you have the mag catch correct side up ...
-
-
1/8 inch allen key for the 1/4-28 set screw
-
Notice the stamping on the smaller parts ,,,,
-
NEXT THE MAG WELL ASSEMBLY
-
Make sure you place this little part in correct,, it is the tension-er for the shoulder part. once aligned first screwing in the set screws to hold it in place.....
-
Now the spring plate and shoulder rest...... alignment is critical and a pain in the butt.. i use a allen key to keep these item in alignment while i put the set screws in from both sides.. Both go all the way in with them yet they need to trap the pivot catch part ........
-
Next is the spring and follower ...
-
First step is to attach the main brace.... two of 10/32 set screw and a 3/32 allen key
-
First im going to start off with the stock assembly,,,,,,,,,
-
Love your build! i do have all the parts in alum if you get stuck on the tougher parts just check out my sites ... -
dont worry,,, idid not do this in a quick small run ... i will have these for the future...
-
From here ill start adding the individual assemblies to show how the kit assembles....
-
-
