Pyrates

Ugh... Yes painting [emoji19] I found that if use painters tape to act as guides you can use toothpicks and a very small amount of paint thinner with q-tips to clean up the exterior edges as well as use the tape again to tape off the black to where you want your interior lines to fall - and use grey paint to cover over any over-spilled black paint if that makes sense.

Git'r'done[emoji106][emoji6]

All is looking good! Question 1: Before you glue the caps on - do the screws holding the TD allow for the air to escape? And have you put a small dab of glue on the nuts inside to prevent them from coming lose? If yes then you can secure the caps and just be sure to check that your TD is in the 7-1/2" length range. When you do glue be careful that the glue does not push out your length - a dumbbell weight on the top can help with this as well as using a twisting motion when your putting on the caps. Question 2: You never know till you try - glue on your strips if you feel comfortable with the size. If you find they are not where they should be then it's easy peasy to pull them apart again and adjust accordingly to what you need. Hope this helps

Sorry mate - been away on vacation and short wifi sessions - none the less keep up the great work and those are some deadly awesome seams!

That's stellar news - and many thanks my friend. I'm looking forward to seeing you two get your ID's - exciting times ahead [emoji38][emoji106]

Awesome progress! As for the thigh ammo pack I believe your marks are a bit high - I got stuck on this one too and spoke with Tony "The key is to ensure the mounts are equally spaced on the return edge" and the ammo pack doesn't have to be centered Here's the link to help out: ukswrath's ANOVOS TK build http://www.whitearmor.net/forum/index.php?/topic/35086-ukswrath%27s-ANOVOS-TK-build

You're going to be done in no time at this rate - great job!

You will get there mate. I was at that point too a few times - listen to the Captain and keep the faith (fist bump)

Great progress - keep at it mate!

Just keep gluing - Just keep gluing [emoji12]

Now I feel old lmao

I can't stop laughing [emoji23][emoji23][emoji23] Shhchck "Hello I'm TK 99725, and I've been off E-6000 fumes for almost a week" Shhchck rotfl

I can't get enough of your enthusiasm kiddo! Make sure you save some of that dough for "Gremlins" (botched snaps, strapping, cover strips and extra E-6000. For the record I ended up needing 5 tubes) - cheers "Punky"[emoji106][emoji6]

Looking really good - keep it up!

Awwwww yaaaaaa!

[emoji106][emoji12]

Looking frosty there Trooper! The webbing/strapping holds it in place - I had the same question when I was testing my dry fits.

White dap silicone using spit on your finger to wipe away excess also works. Just make sure than when your removing the excess to try and wipe the silicone into the gap. Cheers!

Hola! Had to do a quick check to see if you got your tracking number yet. Cheers lass!

Cheers Dave, sorry that I can't check up too much right now - in deep conversation with six sheets to said wind lol. Catch up with you soon!

No worries mon! Cheers Jason, thanks for your guidance and kicks in the butt plate when needed - no word from TM as of yet but drinking too much to notice lol[emoji23]

Stellar work Trooper!

That would be stellar mate and thank you for the kind words!

This is my new favorite http://youtu.be/_n3zzrCF2YQ