TK_LEPER

Try THIS link... this is where all my pics are posted. Maybe I should be uploading to Flickr instead? Jess

where do you attach the pivot point, behind the front strips? anyone have photos?

That's great advice, thanks guys!

You show 'em Nate! Little advice though... Don't waste your time lifting weights, unless you want to be more muscular. Just run it off my friend, trust me. You will burn more fat doing a cardio-related exercise. The more you sweat, the more you burn. And watch your diet, soda is one of the worst. But I wish you all the best. YOU CAN DOO-EET!!

Hey guys! Do you use anything to keep the thighs/shins in place? Like straps, etc. Jess

Great idea, thanks!

Yeah, seen that before. Pretty crazy huh?

It almost looks as though a couple of the buttons were pressed in (partially). That's what I was trying to figure out, why some were lower, etc. And they look like capsules sitting on a block, with a slight overhang. They don't appear to all be of the same size either.

Guess so! Thanks again sir!

GOD I love you! Where did you find that!?

Cool, thank you sir!

Maybe these guys have something that will work? -----

I've noticed that S-trim stuff lately too. It has a round edge (obviously), making more comfortable. I might have to get some. But any rounded trim should work, I would think. -----

I glued mine. Personal preference.

I think I said that somewhere. But I used E6000 under all of my tabs anyhow. PLastic weld will snap right off, with out some E6000 under them. I only used plastic weld around the edges, just for esthetics. E6000 will do the job just fine, just clamp 'em down. The stuff really grips it pretty good. Also, I always scuff up both surfaces with some sand paper, to really give it something to hold onto. When it's smooth, it's more likely to pull off. My Build: ----- Jess

Plastic weld is really only good on the small parts, even on those just around the edges. Listen to my friend and use E6000. Trust us!

Yes, I want to sculpt an original to pull from. And I figured I might as well do it right, if I'm going to do it at all.

Thanks guys! That's about what I had. But I appreciate the time and effort! I was hoping someone had some "behind the scene's" photos of some armor. Maybe it's a lost cause?

Ahh! Thanks for clearing that up! I would love an ABS version for myself.

I thought the TE lid were made out of HIPS... Then what's this?