I got asked about the sniper plate , so here's a few photos
Yeah the sniper plate is a bit problematic, but not impossible. What I did first is I took a long time to kind of ''present it '' like with your hands and a bit of tape, to try to place it where you think it looks right, now , the sides aren't going to fit, so try to see how far from ''ideal' you have to move, the less the better, then I said, ok the sides I can bend a bit, so I took a scale modeling iron and slowly started to heat and bend , it really softens the plastic so you can shape it for it to fit the sides of the shin, I even sanded the shin sides a bit, It's ok the plate is going to cover it , also I made marks on pencil so I could erase them, and I think I cut a bit of the side ends too, Also I added a couple of plastic squares of the same abs because I found that if you place the plate directly over the shin, the two sides end up too far behind.I hope this makes sense, So it's just a matter of patience and slowly heat and bend, here are some photos that I just took for you to see , I hope it helps