Leaderboard

Interesting that Anovos has longer "inner" shin sides. My Walt kit appears to bias longer outside shins. I don't think it matters unless someone else has some insight

Thanks guys! I will look again at the contours. I am following Tony’s build thread @gmrhodes13. These were pre-trimmed when I got this kit and there were no Anovos number stickers on them so that is why I want to make sure I have these correct.

The shins on Anovos was a fun exercise in working out. As stated you cant trust the markings. The way I found it easiest was to look at the line at the bottom if you look at the image in Glens post you can see the sides have a bias at the bottom when in the right place so that the "bigger" side is on the inside.

I had a different kit but the shins didn't line up at all. What's important is that the tops line up and then use a dremel to follow the shape at the bottom and shave one side down until it meets up with the other side

This Anovos build may help "NOTE. Your shins may be mis-labeled by Anovos. The shins come labeled in pairs 24/25, 27/28. A good majority of customers are stating they should be 24/27 and 25/28. Regardless of the numbering system when assembled they should resemble the following image. Note the long swooping outer edge verses the shorter inner. These should resemble the anatomy of your legs. Double check before final assembly."

You have general forum access currently, anyone that signs up to the forum does and it allows you to see certain areas of the forum in regards to finding and building a Stormtrooper costume. You however can not obtain higher access if you are not an approved 501st legion member with an official TKID.

Congratulations trooper!

Welcome, good job trooper! 🥳

Congratulations #1086

Congratulations!!