Jump to content
Peepants130

E11 Blaster Muzzle

Recommended Posts

Somewhere on a troop, the muzzle piece on my blaster went missing. It is a open barrel ANH E11.

Can someone point me in a good direction for a replacement?

 

 

Share this post


Link to post
Share on other sites

Who makes it? That will help for sources for replacing.

Sent from my VK815 using Tapatalk

Share this post


Link to post
Share on other sites

There are 2 alternatives you can use, Michael, resin or aluminum. 

Here is a seller on eBay that sells the resin ones:

https://www.ebay.com/itm/Star-Wars-Stormtrooper-E11-Blaster-Muzzle-38-1mm-Sterling-Mark4-L2A3-SMG/262324234506?hash=item3d13be290a:g:5LkAAOSwoudW3fEQ

Below is a seller I used on my last Doopydoos build to replace the muzzle.  I personally like the sharpness of the aluminum edges.  I cut off the front and had to use a Dremel to thin out the barrel opening so that it would fit, but after some epoxy, sanding and painting it came out great.

https://www.ebay.com/itm/E11-front-barrel-piece-Replica-for-Stormtrooper-blaster/282262850516?hash=item41b82d4bd4:g:rLAAAOSw3RZaM~AZ

NOCM7ko.jpg?1

 

I also used his aluminum parts to replace the mag well, folding stock, magazine and end cap.

 

  • Like 2

Share this post


Link to post
Share on other sites

I believe the one from ebay is not resin but solid plastic?


Sent from my iPhone using Tapatalk

Share this post


Link to post
Share on other sites

Resin/plastic should not matter all that much as long as the sizes are close IMO.

Share this post


Link to post
Share on other sites
19 hours ago, darthcue said:

I believe the one from ebay is not resin but solid plastic?


Sent from my iPhone using Tapatalk

Like Brien mentioned, resin and plastic are both fairly easy to trim.  Resin can be more brittle, though, and easier to chip.

  • Like 1

Share this post


Link to post
Share on other sites

If you know someone with a 3d printer you could have one made.

  • Like 1

Share this post


Link to post
Share on other sites

Think I may have one spare I’ll have a look and it be the cost of postage from uk to where ever you are I’ll look


Sent from my iPad using Tapatalk

Share this post


Link to post
Share on other sites

Sorry guys,

I haven't been ignoring you but eh, holidays.

It is a RS Props model, aluminum barrel type.

 

Thanks for the suggestions.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×