Leaderboard

Good luck with approval trooper

Beautiful! One of the DOs will be with your shortly

Thank you 😊

Hey everyone! Thanks so much for the positive energy and big welcome! Here's my first update: - Right Bicep is rough cut and ready to be sanded down. - Right Forearm is rough cut within a cm of final circumferences (no trim out yet) but it looks weird. The top of the inner piece doesn't have a defined edge, unlike it's twin and the RS Propmasters youtube video. I do have some cutting left but the inner portion is also taller than the outer on both sides. Between the two issues I'm wondering if I have a misfabbed piece or if I just need to power through and trim until it fits. In the pic of the two forearm pieces next to each other, they are aligned on the bottom. You can see the one in question is still taller than the other even after being trimmed. Appreciate any insights! Hoping I didn't screw this up already.

Hi Brent, Thanks for your patience while we looked at your blaster repairs. The blaster definitely looks better and will pass for level 2 (EIB) approval. There are still some print lines visible around the hengstler eagle emblem that we would want cleaned up for Centurion level approval however. We know that they are typically more visible in photos than with the naked eye, but at level 3, we want everything to look as good as possible. With this completed, the only remaining item to get your EIB approval is the positioning of the thermal detonator. We just need you to adjust the positioning of the control panel so it faces backwards. Your thermal detonator control panel is facing a bit too much upward instead of to the back. This can be corrected by carefully unrolling the lower portion of the clips to roll the thermal detonator down. CRL L1: The white control panel raised ribbed pad faces the rear, with the controls/round washer style detail closest to the right end cap. References

Here we go again...