Leaderboard

Hello! My name is Leia, I'm hoping to eventually join by starting with a Rogue One TK 3d Printed Kit from fellow legion member CT-17290, aka Galactic Armory. I have experience with 3d printing, so it's not new to me at all. I'm more nervous about soft parts like boots to be honest! It will be a while until all the parts are assembled and I figure out strapping, so please be patient ORZ. I also eventually hope to get started on a TLJ Executioner, which is my actual favorite subvarient. I'm starting with the ROTK because I don't want to have to figure out things like the rubber gaskets while working on the armor.

Ooh thanks! I had not seen the magnet one.

I use velcro, you just have to make sure you get your closure flat, you may just need to hot water bath them. Also make sure you rough up the surfaces before gluing. Example not closing flat Nice and flat Some have even added extra strips to the closures so they can have wider velcro (I find 12.5mm each side is fine as long as they close flat) Bra hook elastic is screen accurate so some prefer that way Cricket has a nice magnet closure, I may try this mod one day.

I just stole my wife's and ran away!!

More cold casting done. This time, the counter. Casting had a single coat of flat black and then a little buff to take it back Sent from my SM-G950F using Tapatalk