Leaderboard

This is how it turned out

Ears look fine to me, I would put the screws in and see how that affect things, as you say it will help pull things together. Take that pic from a few feet away as you are looking at someones elses TK and not your own and I’m sure you will feel more pleased with your work From a little distance those minor gaps will look more like shadows around the ears While I’m at it, perhaps you plan to revisit the eyes but if not, I would be inclined to trim them some more

I tried it on this pretty old FX chest plate

This is probably best as a two person check on alignment when wearing, you will find the belt on the sides angles upwards towards the back and sits higher on the back so take that into consideration, I think I would trim the grey line if not a little higer. Some references Although the belt has dropped down on the rear notice you can just see the lower corner of the ab/cod which is not covered by the belt Some front and rear references for height Notice this one is cut just under the ridge but this was also to reduce the length of the ab/cod

Day 5: Today I riveted the Helmet together: I personally think it´s quite good. Everything is asymmetrical as it should be I believe. Hopefully you agree. I will start building the Ears this evening. (Hopefully at least) And of course: Thank you everyone for the time you invest in helping me. I appreciate it!

Consider it on the list of CRL updates to discuss this term.

There's been mention of a few details which may be different between R1, Mandalorian and Solo so more research will have to be done, it's not just a case of presumption and adding to a CRL Currently the team are working on TLJ/TLJE so may be some time before we can address other CRL's

I thought about 3d-printing but I do not know anyone who owns a 3D printer. Honestly I would prefer a pre build one on which I don't have to do a lot (maybe some slight changes for centurion). I will also ask in the German garrison forum if anyone has ideas.