3d printed blasters

[Gilbert Lai]

started to explore 3d printing half year ago, now changed to a higher end 3d printer, which I'm very happy about it ~

most important is that I don't need to worry about customs / shipping fee / tax anymore:

 

allow me to show off here :

 

1. SE 14R with real scope:

 

2. Merr-sonn Power 5 (conversion parts only)

 

3. DH 17 

 

4. DLT 20A 

 

exploring to print out T 21B / DLT 19... etc, too many project ahead of me now. 

[Dracotrooper]

Impressive builds, thanks for sharing


Sent from my iPhone using Tapatalk

[justjoseph63[Staff]]

That's quite a collection, Gilbert, and great to see that there is an alternative to having to pay customs and shipping.  I finished building my first attempt at a 3D printed DLT-19 recently, and I gotta say it was a lot of work, but also a lot of fun.  DANG it was a lot of sanding and filling, though!  

 

 

 

 

[gmrhodes13[Staff]]

A very nice collection indeed, just about to start some 3D print builds, I've normally been a from scratch builder but the 3D versions do cut down the work load

[davew1775[501st]]

I’m looking into printing an SE-14 as well. Where did you find the files for yours?

[gmrhodes13[Staff]]

27 minutes ago, davew1775 said:

I’m looking into printing an SE-14 as well. Where did you find the files for yours?

There are files on Thingiverse

[davew1775[501st]]

1 hour ago, gmrhodes13 said:

There are files on Thingiverse

That’s my usual “go-to”. I just wanted to make sure there aren’t better ones nearby. 

[Gilbert Lai]

10 minutes ago, davew1775 said:

That’s my usual “go-to”. I just wanted to make sure there aren’t better ones nearby. 

This is the one I used, so far very happy about it https://www.thingiverse.com/thing:2274864

 

I purchased some files from CG Traders too, but some of them need to adjust its size before printing (I adjust my DLT 20 90% to its original file size)

[Gilbert Lai]

3 hours ago, justjoseph63 said:

That's quite a collection, Gilbert, and great to see that there is an alternative to having to pay customs and shipping.  I finished building my first attempt at a 3D printed DLT-19 recently, and I gotta say it was a lot of work, but also a lot of fun.  DANG it was a lot of sanding and filling, though!  

 

 

 

 

Looks great ! I got a resin DLT19 but too heavy for me, will make a 3d printed version soon.

[Thumpy~[501st]]

very nice 3D work.