tat2trooper

whats that oakland?

i seen that as well.but i was thinking that was only the back thigh.the photos i was looking at ammo belt was covering it so i wasnt sure.dang it.thanks for the heads up.i will peel and trim this one back as well.

so heres a thigh i did.im peeling off the back of the thigh because it wasnt held tightly enough.i finally got some better magnets in so should help alot.once i redo thigh im going to start trimming that back piece while the thigh is drying.

or build a warehouse to store them and create a super cave.

thanks alot.im going to trim it in a little more at least.

Even if I trimmed to no return edge it would still be wider then the front.

check these back piece straps out.they are wider then the chest ones.is that normal? because it doesnt seem so.and i started trimming a little more off but i dont want to lose the return edge on them.what should i do?

ok i will add that to my wish list.and start reasearching for good quality ones that i dont have to work on much.

Ok more magnets finally came.my laptop black screened so I have to figure out a way to add pics without it.and some padding for inside bucket.also quick question do I have to have a holster? I do not own a e11 currently.

I was just trying to figure out how I could cut the eyes and this helped.

holyyyyyy mollyyyyyyyy where do you store all these kits.must have a whole room dedicated to them at least.

man im really proud of myself.im learning a bunch of new stuff thanks to all you helpful troopers.i allready feel great knowing the things i accomplished so far.and look forward to all the little things i do to help me fine tune it and perfect it in any way.im very grateful to found out about this whole journey.thank you 501st.

Sacramento here

Oh my god that's some good news because I was trying my hardest to pop the ends off right now and they stuck like chuck.i even did the air hole trick still stuck on there really good.im gonna put it together.thanks alot.

phew haha.so basically pop ends shorten this tube some.i dont know about plate.i went on the trim line for that.

yea ive checked it out.im on this page every day researching.this was the anovos TD that came with the kit.if i have to purchase a different one i just cant do that right now.spent tons on supplies just ordered boots i need a new neck seal as well because this anovos one looks super cheap and is to tight on my neck.i can in the near future if i have to.because these holes are little farther down then the reference picture ones.

ok

i got it to just slightly bend a little bit.guess i will just focus on pulling straps higher for now on that.mean while how does this look?

thanks for the info im going to try a hot bath in my sink first to see if i can just bend the 2 abs straps upwards slightly.

Yea I probably just have to pull straps tighter I'm thinking so it's up higher.my gf sucks at helping me put it on correctly.

how can i bend the abs straps from back piece? they just like do a sharp turn right into my back.if i could somewhat arch them more would feel and look way better.or am i suppose to just pull them higher up my back with the strapping system.

looks dope bro

I have been taking my time trimming sanding fitting back and forth back and forth making sure I dont take too much I cant get back.i jump from piece to piece to keep myself bizzy.thanks for checking me out brother.

Yea I seen this and I was like phew.my gap isnt that bad after all hahaha.wasnt sure if it had to hug tight onto the bucket or not.

forearms looking good.Reinforced inside of them as well with cleaned up scrap.