Benny22

This was a build by Ross, the maker of RWA kits [emoji2] https://www.facebook.com/media/set/?set=oa.1865590590325848&type=3

Congratulations Julian! That's a great looking kit you've got there [emoji3]

Congratulations Julian! That's a great looking kit you've got there [emoji3]

Thanks! Centurion here I come! [emoji3]

Thank you guys!!

Thanks buddy! [emoji16]

That's great news first thing in the morning, thanks! [emoji16] Can I ask what's the best way to move the shoulder bells in? Or should I put that question on a WIP? [emoji846]

Thanks, is this ok? And it's Simon [emoji6]

Kitted up for a troop today and took the picture for you [emoji3]

Finally got round to it over the Christmas break [emoji16] I think it was seeing your new signature inspired me actually haha! Thanks! [emoji3]

No problem, I'll be kitting up for a troop on Monday so will take that picture then! Thanks [emoji5]

Good spot, thank you! [emoji3] I'll sort that out asap!

Name: Simon Dawson 501st TK ID: 89135 FISD Name: Benny22 Garrison: UK Garrison Profile Page: http://www.501st.com/members/displaymemberdetails.php?userID=26455 Armour Maker: RWA Helmet Maker: RWA Blaster: ShearTech Height: 175 cm approx Weight: 55 kg Boots: Imperial Supply Depot Canvas Belt: RWA Hand plates/gloves: Imperial Supply Depot, Latex Electronics: Aker amp, Troopacoola Neck Seal: RWA Holster: Imperial Supply Depot Link to Armour WIP: http://www.ukgarrison.co.uk/forum/viewtopic.php?f=126&t=66136 Link to blaster build: http://www.ukgarrison.co.uk/forum/viewtopic.php?f=139&t=67625

Congrats Dan, very well deserved! You've done a superb job on the kit and blaster! [emoji106] Sent from my Moto G (4) using Tapatalk

Requesting 501st Access TK-89135 UK Garrison http://501st.com/members/displaymemberdetails.php?userID=26455

Hi Thomas, I'd recommend plenty of trimming followed by bending! If you take a look at my WIP I had a similar problem as my waist is super skinny too. http://www.ukgarrison.co.uk/forum/viewtopic.php?f=126&t=66136&start=15 Be sure to trim both the front and back as equally as you can. Then pour (near) boiling water on the sides and bend to the desired waist shape. In my opinion even if you pad it, it won't look great in the gaps between sections of armour. So better to trim then pad if necessary afterwards. Hope that helps

It was great to watch your progress, congrats on the finished build! [emoji3] Sent from my Moto G (4) using Tapatalk