Jump to content

Executioner Matt black stripe

Recommended Posts

Hi all,


Are there any set measurements for the matt black stripe from the front of the helmet to the rear with regards to the width?


Any guidance would be greatly appreciated.





Link to post
Share on other sites

No exact measurement, I started at the front between the 2nd and 3rd teeth, keep a straight line when masking up and over the top, you can see the gap between the clip and painted line on top of the helmet is wider than the actual clip, then just continue to follow in a straight line directly down the back.


A few references for you




Also don't miss the small extended painted section on the side.




Image result for anovos executioner helmet

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...