ANH Stunt Helmet Frown advice needed.

[Twenin[TK]]

Ok so I was getting ready to plastidip my helmet and I realized an error I made when I first got my helmet. Unfortunately I made the newbie error of assuming on the teeth and not looking at reference pictures. As you can see I cut out 10 teeth instead of 8. I was wondering if anyone has suggestions on fixing this. I was considering filling the small areas with caulk or molding glue like sugru. Any help is appreciated.

Edited July 29, 2017 by Twenin

[Twenin[TK]]

As I was looking for a fix for this I was looking at reference pictures.. I came across this picture in the whitearmor gallery. Does this mean that 10 teeth frowns are considered accurate?

[troopermaster]

It is fine with 10 teeth cut out in my opinion. Less than half of the original helmets have 8 teeth cut out, with several having 10 or 6 as can be seen in this photo of half-finished helmets outside AA's studio in 1976. That said, I don't have the final say, so better wait until one of the leaders chime in.

Edited July 29, 2017 by troopermaster

[Twenin[TK]]

Thanks a bunch! From what I've found so far searching the forums it has been said 6-10 teeth. But I'm going to take your advice and wait for others to comment before I move on.

[Triple D[TK]]

I have ten on mine also. I did the same thing when I built my first TK. 

[68Brick[TK]]

If you are concerned, you could make some ABS paste and fill in two. 

[Locitus[Admin]]

I would keep the 10 teeth. Better to leave it alone than to risk making a mess while trying to "fix" it.