Chopper857's ANH TK Stunt build

[Chopper857[TK]]

Great job there.  well done.

one the paint for the teeth on the helmet  what Humbrol grey did you use?

i used Humbrol Enamel #5 Admiralty grey, spent quite a while with cotton buds and thinners removing all the Anovos over spray first, then went for the re paint adding the small teeth at the ends  they  missed 

[Chopper857[TK]]

First Major troop fast approaching, been working on some minor upgrades re done all the padding in my bucket and finally installed the fans 

 

 

[Chopper857[TK]]

Now doing fitment of Tramp unit, used some leftover helmet adding to help with positioning and stuck in place then checked alignment 

 

then made 2 inch elastic strap glued to chest piece with a supporting off cut over the top once this has cured will double check total length of elastic required 

 

[themaninthesuitcase[Admin]]

I should have used elastic, I used webbing and it's always coming off.

[Novak Dimon[TK]]

Putting some foam under the Speaker is looking like a good idea. I'll try that with my Aker!

[Chopper857[TK]]

both sides now stuck down elastics holding well, foam pads giving a bit of support also and cutting down on the little bit of vibration rattle i had 

 

 

just to finish off stuck mic receiver in place with some standard Velcro

 

[Chopper857[TK]]

now just have to do final clean, polish, check and pack and wait for next weekend   

 

 

ready to roll out