gmrhodes13[Staff] Posted October 30, 2012 Report Share Posted October 30, 2012 First grab a piece of pvc pipe (thick walled), cut it to the right length of the parts you need and then cut a slot down one side Next heat the pipe for a few minutes, you know when it is heated enough as you can see the pipe distort. Open out, don't use fingers to do this as it is hot Then flatten between two pieces of wood and hold down until it's cooled The you have your flat plastic, draw your piece to shape, mine is for side grip cover plates for my DLT-19 Here they are Hope this is a help to some of you Quote Link to comment Share on other sites More sharing options...
MisterFubar[TK] Posted October 30, 2012 Report Share Posted October 30, 2012 I just might have to repurpose some of the PVC scrap laying around in my garage. Thanks for the tip. Quote Link to comment Share on other sites More sharing options...
gmrhodes13[Staff] Posted October 30, 2012 Author Report Share Posted October 30, 2012 I just might have to repurpose some of the PVC scrap laying around in my garage. Thanks for the tip. You are welcome Just thought I would add that I do scuff the pvc before glueing, so it gives the glue something to bite on to Quote Link to comment Share on other sites More sharing options...
Clamps[TK] Posted October 30, 2012 Report Share Posted October 30, 2012 nice tip Glen! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.