TK5492[TK] Posted September 22, 2012 Report Share Posted September 22, 2012 Looks much better now. Great work with it! I hate to be a stickler about it but the cover strips aren't supposed to come down over the raised portion of the bottom of the thigh, just right up to it. That would also make the cover strip lay flat, as I can see it is angling up to accomodate the changing surface. Quote Link to comment Share on other sites More sharing options...
Neo Posted September 23, 2012 Author Report Share Posted September 23, 2012 Looking good! Is it too much to ask for a new set of suited up pictures to help gauge the overall look with these new improvements? Quote Link to comment Share on other sites More sharing options...
Locitus[Admin] Posted September 26, 2012 Report Share Posted September 26, 2012 Thanks. No doubt that you've done a great job on this. But there are still some issue to be addressed. Specifically better glued down hand guards, as mentioned earlier. The excess of the belt should be cut off so it doesn't have that "tail" and a new thermal detonator as well. A new pair of shoulder bells would be highly recommended as well. Or at least heat formed to be less bulky in relation to your smaller body. Quote Link to comment Share on other sites More sharing options...
TK5492[TK] Posted September 26, 2012 Report Share Posted September 26, 2012 I hate to bring this up as there has already been so many adjustments, but I would also recommend that the tube stripes are moved up. Right now they are too far from the "valley" between the cheek and tube. I believe it is supposed to be about as far away as the width of a standard pencil? These look about an inch or more. Quote Link to comment Share on other sites More sharing options...
Locitus[Admin] Posted September 26, 2012 Report Share Posted September 26, 2012 That's true, they are a little low. Quote Link to comment Share on other sites More sharing options...
Neo Posted October 4, 2012 Author Report Share Posted October 4, 2012 I am ordering another set of bells Quote Link to comment Share on other sites More sharing options...
Spectre Posted October 6, 2012 Report Share Posted October 6, 2012 You could just trim them a little and use boiling water to reshape them and make them more accurate. That's what I intend to do with my AM bells. Quote Link to comment Share on other sites More sharing options...
Spectre Posted October 7, 2012 Report Share Posted October 7, 2012 Like so: http://www.whitearmor.net/forum/index.php?showtopic=21412#entry265769 Hope that helps. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.