DudeSidious Posted October 19, 2011 Report Share Posted October 19, 2011 With the standerd size joining strip you will see the lap join molding.What size cover strip do I use? Quote Link to comment Share on other sites More sharing options...
kaptinkaos Posted October 19, 2011 Report Share Posted October 19, 2011 25mm is what I used on the back of my shins (AM kit). Quote Link to comment Share on other sites More sharing options...
gazmosis[501st] Posted October 19, 2011 Report Share Posted October 19, 2011 25 MM is the standard for the rear of the thighs and shins. Don't worry about the other raised areas on either side of the partition. Just make sure your cover strip is centered. Quote Link to comment Share on other sites More sharing options...
tkrestonva[TK] Posted October 20, 2011 Report Share Posted October 20, 2011 Also, before you glue anything make sure you have accounted for the mis-molded shins that is a well-known AM design flaw. It looks like you have, but it's always been difficult for me to see it clearly - even on my own AM kit. Tom (Roguetrooper) did an outstanding tutorial describing the problem and how to solve it, I'll see if I can dig it up. Quote Link to comment Share on other sites More sharing options...
BananoPower22[TK] Posted October 20, 2011 Report Share Posted October 20, 2011 (edited) i think this is it = Edited December 4, 2020 by gmrhodes13 link not working, removed gmrhodes13 2020 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.