Jump to content

SpikedGoat

Member
  • Posts

    53
  • Joined

  • Last visited

Everything posted by SpikedGoat

  1. Thank you everybody for your help. I have finished and I have just gotten the approval! Thank you all again!
  2. Hello, TK76000 Requesting 501st access. http://www.501st.com/members/displaymemberdetails.php?userID=16678
  3. Thank you, I will take a look at lowering the wings on it. Its pretty tight already, moving it lower wont move it back any. I have pretty thick thighs.
  4. I fixed the split rivets. 10mm from the split. Spaced evenly along the side. Cap Rivets on the Battery back. How did these turn out?
  5. Before I make the same mistake twice... How do these holes look? I still have alot more painting/sanding/filler work left.
  6. Is that a deal breaker for Centurian? Should I move it? If I move it I have to move the middle one too to get the spacing right. This is what i would need to do to fix it?
  7. Split rivets attached. (Sorry for the distored Picture) Do these look ok?
  8. What are the male snaps that I use for the butt plate and the right of the Ab plate? Are these the line 24 snaps? The pictures I have seen are different then what I have.
  9. So Im looking at this guide and before I cut and drill holes I wanted to make sure I have it right. (I have not measured anything this is just eyeballing) I want to make sure the Dropbox's line up with the end of the belt? Or are the rivet covers aligned with the center of the drop boxes? The drop boxes dangle from the sides of the front plastic belt (ammo belt) via white straps and are aligned under the plastic tabs of the ammo belt. Drop boxes are vertically aligned with the end of the ammo belt with minimal gap between belt and box. I think I need to shorten the belt.
  10. It is been awhile since I have had free time to work on it. Here are some of my updates / Questions. Completed TD: Added Supports: Questions How do I cut this? Do I make it just flat around the raised part? Same with this one? How does my trim line look? How high does this stick out? This is a rough mock up of the belt. How do the 45deg cut lines look? Do the covers here need to be flush on the belt or have a little return edge to raise them up a little? Do the covers need to be spaced from the edge of the belt? Thanks again for all the help.
  11. Drop boxes: Dry fit Back: Front: Battery Pack: I am not sure how to mount this. I now there is a rivet, but I don't know which one? I have not bought a river gun yet I do have a few brass snap rivets. Any help would be great. How does the the placement look?
  12. Ear Update: I dropped one of the ears a little it is a much better fit. Sniper plate: Its glued, hope I didnt screw up....
  13. Thank you, I will drop those lower tonight. After you suggested it I think that will help alot.
  14. Helmet Status: I don't think ill ever be happy with the ears so I'm stopping for now before I screw it up. It doesn't look too bad. @SpikedGoat
  15. Bucket Building: Ear still a work in Progress. (I had to take a break before I went crazy.) Sniper Plate Test Fitting:
×
×
  • Create New...