Leaderboard

Chemi, I have done some clean up on the teeth and attached the other photos, thanks again for your help. .

This just received from Denuo Novo. Time to move my TFA build log that I just created to the TLJ section. LOL Hi Daryl, The helmet will be The Last Jedi. Thanks and MTFBWY! Denuo Novo Customer Service

The sheet has been cut, sewed, and dyed and is now the cape! Velcro on the shoulder straps to secure it Test fit Now I gotta muddy the cape

It’s been 4 years since I’ve cut any plastic, and I’m terrified of cutting a kit I’m not very familiar with. I thought about just leaving it in the box for awhile until someone else creates a build post for me to follow, but then the Denuo Novo instructions were released today, so I figured why not just jump in. So here goes, its arm day! Rough cutout. Biceps inner before: Bicep inner after: Bicep outer before: Bicep outer after: Forearm outer before: Forearm outer after: Forearm inner before: Forearm inner after: I plan to rough cut all pieces to outside the guide lines, then sand to the proper size.

20mm is a guide, a mm here or there isn't too important. I personally try to stick to 20mm References Shins are @20mm front and @25mm on the rear, this is because of the velcro closure

I had some spare prototype parts lying around, my workmate andrew donated the sandy pauldron and the MP40 pouches. After a few hours today I managed to put this together.

One of the other things that distracted me from starting my build is that I wanted to 3D print my E-11. I had always wanted to buy a 3D printer so took this perfect opportunity to get one. I used @trooper96's wonderful files and instructions which made it very easy. Also, @justjoseph63's post on how to smooth out the pieces was very helpful. Here is the finished product. Let me know if there are any areas for improvement.