Leaderboard

Basic Information Name: Jared Snow FISD forum name: BigBadFun 501st Member Page: http://www.501st.com/members/displaymemberdetails.php?userID=23130 501st ID: TK-27970 Garrison: Outpost 42 (New Zealand) Mandatory Information Armor Maker = RS Propmasters (Self build) Helmet Maker = ATA Works (Self build) Blaster Type = RS Propmasters DLT-19 Optional Information Height = 6'0" Weight = 187 pounds Boots Maker = TK Boots Canvas belt = RS Propmasters Hand Plates Type = RS Propmasters Electronics = 10w Aker + Troopertalk App Neck Seal Type = Darman @ FISD Holster Maker = Darman @ FISD Front – Arms at side Back – Arms at side Left – Arm raised Left Side Detail – Arm raised Right – Arm raised Right Side Detail – Arm raised Helmet off Abdomen Details Action Shot Cod and Butt Plate Attachment Interior Strapping Helmet Front Helmet Left Helmet Right Helmet Back Helmet Hovi Tip Detail Helmet Lens Color Helmet S-Trim (updated) Blaster Neck Seal Thermal Detonator – Back Back of Belt Holster Attachment Thigh Ammo Pack Left Thigh Ammo Pack Right Thigh Ammo Pack Rivet

Hengstler sol progress,,,

Nearly there and done. Going to raise up and uncurve the 4 helmet clips, get it prototyped and ready for casting.

Next I soldered the RBG LED for the front and rear lights. Bottom of the picture is all the parts. The top is a completed light. I took the barrel from Aaron and cast the camber section. I did this so I could mount an RBG LED. I drilled a hole for the LED and then some channels for the wires. I did two 90 degree bends so the wire would protrude to the front. I also cut the green wire off. When this is finished I will cover everything with green stuff. I then soldered the wires for future connection

good job brother!!!

Thank you, i am very excited.

Good Luck Antonio!

Nice work Antonio. Good luck!

You are a helmet modding wizard my friend! sent from my phone