Colberto Posted July 31, 2025 Report Posted July 31, 2025 (edited) Hey everyone, I bought some TD clips for my thermal detonator, had them glued and screwed. But have a problem with bending the clips and i’m not sure if a hammer or clamps would hold it down enough. Is there a way I can bend the clips without breaking them? Thank you! Edited July 31, 2025 by Colberto Quote
Colberto Posted July 31, 2025 Author Report Posted July 31, 2025 Sent from my iPhone using Tapatalk Quote
Colberto Posted July 31, 2025 Author Report Posted July 31, 2025 Sent from my iPhone using Tapatalk Quote
Colberto Posted July 31, 2025 Author Report Posted July 31, 2025 Sent from my iPhone using Tapatalk Quote
Colberto Posted July 31, 2025 Author Report Posted July 31, 2025 Sent from my iPhone using Tapatalk Quote
Colberto Posted July 31, 2025 Author Report Posted July 31, 2025 Sent from my iPhone using Tapatalk Quote
Colberto Posted July 31, 2025 Author Report Posted July 31, 2025 Sent from my iPhone using Tapatalk Quote
gmrhodes13[Staff] Posted July 31, 2025 Report Posted July 31, 2025 You will find that WTF (and a few others) use a lot smaller diameter pipe so standard sized clips are too big, I found a piece of metal pipe the same size as the plasitc pipe then gently hammered to get the clips to sit flatter. If you can't find metal pipe try to clamp the clips between 2 pieces of metal and a vice and apply pressure on the areas needing adjusting, you should be able to move the pieces of metal to other areas to curve the clips better. This may be of help AP also use smaller pipe Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.