Colberto

Well in that case, how should I remove the white bruises? I think it happens when i bend the plastic.

Sent from my iPhone using Tapatalk

I managed to get this installed to my thigh without the need of a heat gun or boiling water. However, I can't help but see that theres a white bruise on the left side of the belt (kinda hard to see). i'm concerned that it might be a sign that the belt might break. I might have to consider doing the "unthinkable", which is using a heat gun at this point due to the piece being glued. If I were to do it, I will need to be very careful because I painted the rivets white with humbrol paint (which is flammable) and might have to use aluminum tin foil to prevent the plastic from burning. Any suggestions?

Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

Hey everyone, I bought some TD clips for my thermal detonator, had them glued and screwed. But have a problem with bending the clips and i’m not sure if a hammer or clamps would hold it down enough. Is there a way I can bend the clips without breaking them? Thank you!

No need! I’ve already got a replacement and had it installed to my left thigh. But thanks for for tips! 👍

Sent from my iPhone using Tapatalk

I’m wondering if you guys have any helpful tips for flexing the ammo belt that goes around the thigh for my tk without using a heat gun? The Last time I use a heat gun it didn’t end well when I tried connecting it with the thigh.