Bubble lens question

[RLH2515[TK]]

Ok so have you guys who installed the bubble lens rounded the whole for the lens? Or have you just bent the lens a little ? What worked for you.

 

 

Sent from my iPhone using Tapatalk

[gmrhodes13[Staff]]

I followed the natural curve of the eyes and my bubble lenses sat quite flush

[RLH2515[TK]]

as you can see in the picture it touches the center of the buckets eye socket. I figure just round the center a little to accept the lens. Thoughts ?

 

 

Sent from my iPhone using Tapatalk

[humperdingle]

There was a ROTJ build recently, where the builder made an amazing job on the eyes... check out over in the ROTJ builds section.

[RLH2515[TK]]

Thank you

 

 

Sent from my iPhone using Tapatalk

[RLH2515[TK]]

Didn't see any posts that help me. So I'm going to dremel the eye socket to accept the bubble lens a little better. I read that some gap helps with ventilation "somewhat"

 

 

Sent from my iPhone using Tapatalk

[humperdingle]

Didn't see any posts that help me. So I'm going to dremel the eye socket to accept the bubble lens a little better. I read that some gap helps with ventilation "somewhat"

Sent from my iPhone using Tapatalk

This one... post #192 particularly.

http://www.whitearmor.net/forum/topic/37102-rotj-reinforcement-for-austria-the-empire/page-10