Screen accurate WIP, advice needed.

[Hunterdisarm]

My MTK kit finally shipped, so I'm going to post my WIP now.<br><br>
This is my first build and I am aiming to build for Centurion. If there are any points of screen accuracy beyond centurion requirements, please share? 

Armor: MTK (Shipped) 
Helmet: MTK (Shipped) 
Boots: TKBoots (On-Hand) 
Under Suit: Under Armour (OH) 
Belt: DIY (OH) 
Holster: Darman (OH) 
Neck seal: Darman (OH) 

Blaster: Hyperfirm (Ordered) 

 

Here is the belt I crafted as I wait for my kit to arrive. Layers of fraying canvas, white denim twill weave outer and white satin lined. Just like the originals according to my research.

I cut the strips 8cm wide. I added a layer of very heavy fusible interfacing that I cut slightly narrower than the canvas

I pinned the inner 4 layers together and stitched about an inch in to reinforce everything.

Then I pinned the denim strip and folded over my satin liner and stitched them in one go.

I also whipped up some wire brackets for my elastic setup:

Edited May 25, 2016 by Hunterdisarm

[Locitus[Admin]]

These two links should have you covered.

 

http://www.whitearmor.net/forum/topic/26477-what-we-know-about-strapping-snaps-rivets-etc/

 

http://www.whitearmor.net/forum/gallery/category/7-general-stormtrooper-reference/